User manual AEG-ELECTROLUX DD9996-B

[. . . ] Never use the hood for purposes other than for which it has been designed. Never leave high naked flames under the hood when it is in operation. Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. [. . . ] If within 5 sec the panel does not open or close, the motor stops. When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120mm, the choice of which is left to the installer. Fix the pipe in position using sufficient pipe clamps (not supplied). Fix the pipe in position using sufficient pipe clamps (not supplied) . Screw the filter cover onto the air outlet, using four screws 12c (2. Fix the air outlet grid 8 on the recirculation air outlet using the 2 screws 12d (2, 9 x 9, 5) provided. Remove the metal filters (See Part "MAINTENANCE") and make sure that the connector piece of the supply cable is correctly inside the hood socket. Slightly widen the two sides of the upper chimney and hook them behind the brackets 7. 1, making sure that they are well seated. Slightly widen the two sides of the chimney and hook them between the upper chimney and the wall, making sure that they are well seated. Fix the lower part laterally to the hood body using the 2 screws 12c (2, 9 x 9, 5) supplied. Upper panel closed: when pressed for about two sec-ond it opens the upper panel. it switches the motor on at the latest selected speed. Upper panel open: when shortly pressed it switches the motor and the lights on/off. The function is suitable for cooking conditions when vapours and smells are of the at most emission. functioning only when the upper panel is open. By pressing this key it is possible to set up the motor to a suction speed at 100 m3/h . By pressing this key for about 2 seconds it is possible to reset the filter saturation alarm. The alarm is triggered after 100 working hours. c indicates that the charcoal filter satura-tion alarm has been activated , and the filter has to be replaced. The alarm s triggered after 200 working hours. By pressing this key the intensity of the lighting sys-tem can be modified up to five levels. [. . . ] In case the fuser gets damaged when the panel is closed it is be necessary to manually unblock the panel. in this case proceed as follows: · Remove the cover placed up on the left side. Press the releasing lever with the screwdriver as much as necessary to enable the manual opening of the panel. After having completely opened the panel remove the metal grease filters, as explained in the part concerning the filter cleaning. [. . . ]