User manual AEG-ELECTROLUX DF 7190

[. . . ] The minimum safety distance between the cooker top and the extractor hood is 650 mm (some models can be installed at a lower height, please refer to the paragraphs on working dimensions and installation). Check that the mains voltage corresponds to that indicated on the rating plate fixed to the inside of the hood. The route of the flue must be as short as possible. If the extractor is used in conjunction with non-electrical appliances (e. [. . . ] Instead The symbol it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. The Hood can be fitted directly on the lower surface of the Wall Units (650 mm min. Above the Cooker Top) using the snap-on Side Supports. Make an opening on the lower surface of the Wall Unit, as indicated. If the cabinet is without bottom, fix the two brackets at a distance B of minimum 30mm and maximum 60mm. Before carrying out the installation, the wooden transportation protections screwed on the visor and on the canopy body must be removed. Choose the correct flange measure basing on the air outlet diameter and insert it to the upper air outlet opening. Screw the closing profile 20 onto the rear part of the hood, using the screws 12f (2. Insert the Hood until the snap-on side sup-ports click into place. Lock in position by tightening the screws Vf from underneath the Hood. If necessary, adjust the whole filter holder unit and proceed as follows: · Move the entire filter holder unit until it is properly aligned with the wall unit. Keeping the hood canopy still, remove the sliding panel and lock the adjustment screws again. The hood can now be fastened to the wall unit using the four screws 12a (3. When installing the hood in ducting version, a rigid or a flexible pipe with the diameter corresponding to the flange diameter is used in order to connect the hood to the air outlet piping. Fix the pipe with an adequate quantity of clamps (not supplied). Cut a hole ø 125 mm in any shelf that may be positioned over the hood. [. . . ] (The colour of the filter surface may change throughout the time but this has no influence to the filter efficiency). When refitting the filters, make sure that the handle is visible on the outside. These filters are not washable and cannot be regenerated, and must be replaced approximately every four months or more frequently by particularly heavy use. Fit the new filter by hooking it into its seating. [. . . ]