User manual AEG-ELECTROLUX DF4160-ML

[. . . ] Failure to do so could cause grease deposits to build up, resulting in a fire hazard. The appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the appliance. WARNING - Ensure that the appliance is switched off before replacing the lamp to avoid the possibility of electric shock. For the installer When used as an extractor unit, the hood must be fitted with a 120mm diameter hose. [. . . ] Select most powerful washing programme and highest temperature, at least 65°C. Refit the grease filters when they are dry. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance. Clean the inner housing using a hot detergent solution only (never use caustic detergents, abrasive powders or brushes). Fig. 4 60 Charcoal filter The charcoal filter should only be used if you want to use the hood in the recirculation function. To do this you will need an original AEG charcoal filter (available from your local Service Force Centre). Replacing the charcoal filter The charcoal filter must normally be replaced at least once every year. This filter cannot be washed or regenerated. To guarantee proper absorption of odours the working volume of the charcoal must be proportionate to the hood air flow. In this case the high quality of the charcoal will ensure efficient odour removal for approximately one year, assuming that the hood is used normally. For this reason you should always use original AEG filters only, making sure they are replaced when necessary. Fitting Pull out the drawer, remove the grease filter. Fit the charcoal filter so that it covers the grilles protecting the hood motor and fan, turn the carbon filter handle P in a clockwise direction. Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the registration plate located on the inside of the unit. The charcoal filter can be ordered from your local Service Force Centre. P P Fig. 5 61 Warning Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulb Disconnect the cooker hood from the main supply. Remove the lamp cover, use a screw driver as a lever. Replace the old bulb with a new one of the same type. If the light does not come on, make sure the bulb has been inserted in correctly before contacting the technical assistance service. Fig. [. . . ] 10 69 Install a discharge tube on the connection ring C supplied, preferably with a diameter equivalent to the connection ring (Fig. the discharge tube should be sufficiently long to reach outside (Suction version) or the ceiling of the wall cabinet (Filter version). Fix the connection ring C (snap into place), at the upper exit of the cooker hood. To ease the installation, the ring is equipped with an index G that should correspond to the appropriate guide H placed on the upper air exit. C G H Fig. [. . . ]