User manual AEG-ELECTROLUX DF45-30SS

[. . . ] When installing the hood, make sure you respect the following minimum distance from the top edge of the cooking hob/ring surfaces: electric cookers 500 mm gas cookers 650 mm coal and oil cookers 800 mm min. If the instructions for installation for the gas hob specify a greater distance, this has to be taken into account. The national Standard on fuel-burning systems specifies a maximum depression of 0. 04 bar in such rooms. 55 The air outlet must not be connected to chimney flues or combustion gas ducts. The air outlet must under no circumstances be connected to ventilation ducts for rooms in which fuel-burning appliances are installed. [. . . ] Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders. Only ever clean the switch panel and filter grille using a damp cloth and delicate detergents. It is extremely important to clean the unit and change the filters at the recommended intervals. Failure to do so will cause grease deposits to build up that could constitute a fire hazard. Cleaning the glass vapour screen The glass be dismounted and cleaned using a normal glass detergent. Instructions for removing the glass (Fig. Lightly push the glass downwards and allow it slide forwards. Remove the glass allowing it to rotate slightly. After cleaning, follow the instructions in reverse to remount the glass. Fig. 3 59 Metal grease filter The purpose of the grease filters is to aspirate grease particles which form during cooking and it must always be used, either in the extraction or internal recirculation function. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulb Disconnect the cooker hood from the main supply. Remove the lamp cover, use a screw driver as a lever. Replace the old bulb with a new one of the same type. If the light does not come on, make sure the bulb has been inserted in correctly before contacting the technical assistance service. Fig. 6 Special accessories Charcoal filter TYPE303(*) (*) Only for UK: The charcoal filter can be ordered from your local Service Force Centre, please, disregard the reference code reported above. 62 What to do if If your appliance fails to work properly please carry out the following checks. Symptom The cooker hood will not start. . . Solution Check that: The hood is connected to the electricity supply. Check that a fan speed has been selected Check that: The fan speed is set high enough for the task. The kitchen is adequately vented to allow the entry of fresh air. If set up for recirculation, check that the charcoal filter is still effective. [. . . ] Appliances fitted with a plug can be connected to any standard power socket within easy access. Should it be necessary to provide a fixed connection, the hood must only be installed by an electrician authorised by the local electricity board. When installing, an omnipolar disconnector with a distance of at least 3 mm between contacts must be provided. Fixed connection of the appliance must only be carried out by an authorised electrician. Electrical connection for UK only Safety warnings for the electrician Connect the hood to the mains supply via a double pole switch which has 3 mm minimum separation between the contacts. [. . . ]