User manual AEG-ELECTROLUX DF6162B-CH

[. . . ] Failure to do so could cause grease deposits to build up, resulting in a fire hazard. The appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the appliance. Only for model DF6161: when used as an extractor unit, the hood must be fitted with a 120mm diameter hose. [. . . ] Refit the grease filters when they are dry. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance. Clean the inner housing using a hot detergent solution only (never use caustic detergents, abrasive powders or brushes). The charcoal filter should only be used if you want to use the hood in the recirculation function. To do this you will need an original AEG charcoal filter (available from your local Service Force Centre). replacing the charcoal filter Type 150 This filter cannot be cleaned or reused. As a general rule, the activated charcoal filter should be changed once every 12 months. Cleaning/replacing the charcoal filter Type 150 LONG LIFE Unlike other charcoal filters, the LONGLIFE charcoal filter can be cleaned and reactivated. At normal use the filter should be cleaned every second month (when using the hood 2, 5 hours per day, on avarage). The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest temperature (65º C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. To reactivate the charcoal, the filter should be dried in an oven for 10 minutes with a maximum temperature of 100ºC. After approximately three years of use, the charcoal filter should be replaced with a new, as the odour reduction capacity will be reduced. Remove first the rear then the front grease filters. Insert the charcoal filter into the lugs of the frame above using the 2 red clips to retain it, press the red clips inwards, and insert the charcoal filter in the frame. Press both red lugs upwards (towards the inside of the housing) and remove the charcoal filter downwards. Clean the internal housing only with warm washing-up liquid suds (never use any abrasive cleaners, brushes, or scouring agents). Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the registration plate located on the inside of the unit. The charcoal filter can be ordered from your local Service Force Centre. You are therefore strongly recommended to follow these instructions. [. . . ] Fix the holding frame on the lower part of the housing of the hood with the 2 screws supplied. Removing the hood from the wall unit If, for technical reasons (extraction version/recirculation version conversion) the extractor hood has to be removed from the wall unit, proceed as follows: Fully withdraw the visor and remove the grease filter. 15 On wall units with a body depth of 275 mm to 335 mm, the visor depth can be adjusted as follows: Remove both grease filters. Installing the front panel (see also Special accessories) Remove first the rear then the front grease filters. [. . . ]