User manual AEG-ELECTROLUX DF6163-M

[. . . ] The hot oil in the frying pan might ignite due to overheating. The risk of self-ignition increases when the oil being used is dirty. it is extremely important to note that overheating can cause a fire. Never carry out any flambé cooking under the hood. [. . . ] It should be left on after cooking for about 15 minutes or until all odours have disappeared. The hood must always be disconnected from the electricity supply before beginning any maintenance work. Clean the outside of the hood using a damp cloth and a mild washing up liquid solution. Only ever clean the switch panel and filter grill using a damp cloth and mild washing up liquid solution. It is extremely important to clean the unit and change the filters at the recommended intervals. Failure to do so will cause grease deposits to build up that could constitute a fire hazard. The purpose of the grease filters is to aspirate grease particles which form during cooking and it must always be used, either in the extraction or internal recirculation function. Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. Hand washing Soak grease filters for about one hour in hot water with a grease-loosening cleaner, then rinse off thoroughly with hot water. Refit the grease filters when they are dry. dishwasher Place grease filters in dishwasher. You are therefore strongly recommended to follow these instructions. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Disconnect the unit from the mains power supply. Unlock the lighting cover (D) by twisting the bolts to the left and fold down the bulb cover. Replace the old light bulb(s) with a new light bulb of the same kind. Close the bulb cover and relock it by twisting the bolts to the right. If the light does not come on, make sure the bulb has been inserted correctly before contacting your local Service Force Centre. Contact our Service Force Centre Available from your retailer as an accessory Available from your retailer as an accessory ET-NR. If your appliance fails to work properly please carry out the following checks. Check that a fan speed has been selected Check that: The fan speed is set high enough for the task. The kitchen is adequately vented to allow the entry of fresh air. [. . . ] When installing, an omnipolar disconnector with a distance of at least 3 mm between contacts must be provided. Fixed connection of the appliance must only be carried out by an authorised electrician. Connect the hood to the mains supply via a double pole switch which has 3 mm minimum separation between the contacts. the switch must be accessible at all times. [. . . ]