User manual AEG-ELECTROLUX DF6164-M

[. . . ] Children should not be allowed to tamper with the controls or play with the appliance. ⷠNever use the hood without effectively mounted grating! ⷠThe hood must NEVER be used as a support surface unless specifically indicated. ⷠThe premises where the appliance is installed must be sufficiently ventilated, when the kitchen hood is used together with other gas combustion devices or other fuels. [. . . ] Press the handle locking the grease filter first towards the opposite side then down. 3 Hand washing Soak grease filters for about one hour in hot water with a grease-loosening cleaner, then rinse off thoroughly with hot water. Refit the grease filters when they are dry. dishwasher Place grease filters in the dishwasher. Select most powerful washing programme and highest temperature, at least 65°C. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance. ⷠClean the inner housing using a hand hot solution only(never use caustic detergents, abrasive powders or brushes). The charcoal filter should only be used if you want to use the hood in recirculation mode. ⷠTo do this you will need an original charcoal filter (Available from your local Service Force Centre). As a general rule, the activated charcoal filter should be changed once every 4 months. Fit the charcoal filter so that it covers the grilles protecting the hood motor and fan, turn the carbon filter handle P in a clockwise direction. Always specify the hood model number, serial number and product number code when ordering replacement filters. This information is shown on the rating plate located on the inside of the unit. ⷠThe charcoal filter can be ordered from your local Service Force Centre. You are therefore strongly recommended to follow these instructions. ⷠThe manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Prior to touching the light bulbs ensure they have cooled down. ⷠRemove the lamp cover, use a screw driver as a lever. Replace the old bulb with a new one of the same type. If the light does not come on, make sure the bulb has been inserted in correctly before contacting your local Service Force Centre. Clean the outside of the hood using a damp cloth and a solution of water and mild washing up liquid. Only ever clean the switch panel and filter grill using a damp cloth and mild washing up liquid. [. . . ] Insert the cooker hood in the wall cabinet, ensuring to position the cooker hood bracket E above the wall cabinet bracket D (Fig. Block the cooker hood with two screws on the frontal part (Fig. If the cooker hood should not touch perfectly with the lower border of the wall cabinet then regulate by loosening the screws P of the brackets E mounted on the cooker hood (Fig. 7), it will be possible to regulate the perfect matching of the cooker hood and wall cabinet, once regulated tighten the screws. [. . . ]