User manual AEG-ELECTROLUX DF6861M

[. . . ] 65 Extraction mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 65 Recirculation mode . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 65 Control Panel . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 66 Maintenance and Care . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The extractor part (visor) of the hood is used to switch the fan on and off when the appliance is switched on (Motor). When the visor of the appliance is withdrawn, the fan automatically switches on. If the visor is pushed in without operating the switches, the fan is switched off. The lighting can be separately switched on and off with the slide switch. Turn the hood on a few minutes before you start cooking then you will get an underpressure in the kitchen. It should be left on after cooking for about 15 minutes or until all odours have disappeared. 66 Maintenance and Care · The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood · Clean the outside of the hood using a damp cloth and a mild washing up liquid solution. · Never use corrosive, abrasive or flammable cleaning products. · Never insert pointed objects in the motor's protective grid. · Never use caustic detergents or abrasive brushes or powders. · Only ever clean the switch panel and filter grill using a damp cloth and mild washing up liquid solution. · It is extremely important to clean the unit and change the filters at the recommended intervals. Insert the charcoal filter into the lugs of the frame above using the 2 red clips to retain it, press the red clips inwards, and insert the charcoal filter in the frame. Press both red lugs upwards (towards the inside of the housing) and remove the charcoal filter downwards. Clean the internal housing only with warm washing-up liquid' suds (never use any abrasive cleaners, brushes, or scouring agents). · Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the registration plate located on the inside of the unit. · The charcoal filter can be ordered from your local Service Force Centre. Fig. 3 68 Warning · Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. · The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulb(s) · Disconnect the unit from the mains power supply. · Unlock the lighting cover (D) by twisting the bolts to the left and fold down the bulb cover. Replace the old light bulb(s) with a new light bulb of the same kind. [. . . ] · Important: Detach and insert the grease filters only when the visor is fully withdrawn. First remove the rear and then the front grease filter. · For 19 mm side walls, the spacer discs clipped in on the appliance body must be taken out. Mount the hood with 4 or 6 x Ø 4 mm screws. [. . . ]