User manual AEG-ELECTROLUX DF7190-M9

[. . . ] gas burning appliances), a sufficient degree of aeration must be guaranteed in the room in order to prevent the backflow of exhaust gas. The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. USE · The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. · Never use the hood for purposes other than for which it has ben designed. [. . . ] (fig. 5) · Open the sliding suction panel. · Remove the metal grease filters one by one by turning the hooks provided. · Close the sliding suction panel again. · Insert the Hood until the snap-on side supports click into place. (fig. 6) · Open the sliding suction panel. · Lock in position by tightening the screws Vf from underneath the Hood. (fig. 6) · If necessary, adjust the whole filter holder unit and proceed as follows: · Loosen the four adjustment screws Vr and close the sliding panel again. (fig. 7) · Move the entire filter holder unit until it is properly aligned with the wall unit. (fig. 8) · Keeping the hood canopy still, remove the sliding panel and lock the adjustment screws again. (fig. 7) · The hood can now be fastened to the wall unit using the four screws 12a (3. 5 x 16) provided. (fig. 9) · Replace the metal grease filters. · Close the sliding suction panel again. 1 162 523 2 10b 10a 9 3 10a 4 5 6 Vr 7 8 12a 9 EN 1 16 Connections DUCTING VERSION AIR EXHAUST SYSTEM When installing the hood in ducting version, a rigid or a flexible pipe with the diameter corresponding to the flange diameter is used in order to connect the hood to the air outlet piping. · Fix the pipe with an adequate quantity of clamps (not supplied). · Remove possible charcoal filters. pipe RECIRCULATION VERSION AIR OUTLET · Cut a hole ø 125 mm in any shelf that may be positioned over the hood. · Insert the flange 10a on the hood body outlet. · Connect the flange to the outlet on the shelf over the hood using a flexible or rigid pipe ø120 mm. · Fix the pipe in position using sufficient pipe clamps (not supplied). · Fix the directional grille 8 on the recirculation air outlet using the 2 screws 12e (2, 9 x 12, 7) provided. · Ensure that the activated charcoal filters have been inserted. 12e 8 ELECTRICAL CONNECTION · Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. . EN 1 17 USE L M By pulling out the sliding panel it is possible to automatically activate all the hood functions. [. . . ] · Remove the saturated carbon filter by releasing the fixing hooks · Replace the grease filters. · Close the sliding suction panel. Lighting LIGHT REPLACEMENT 11 W fluorescent light. · Remove the metal terminals fixing the glass. · Slide the glass cover to the right until the left hand is free. [. . . ]