User manual AEG-ELECTROLUX DH1690-M

[. . . ] Notice d'utilisation Instructions for use Bedienungsanleitung Instrucciones para uso The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. [. . . ] Make sure that once the appliance is installed it is easily accessible by a technician in case repairs are required in the future. incorrect installation may make the hood unsafe. The installation must be in conformity with local statutes regulating the evacuation of waste air. 1) Before installing the appliance, make sure that none of the parts is damaged in any way. In case of damaged parts, contact your retailer and do not proceed with installation. Read all of the following instructions with care before installing the appliance. For optimal performance in evacuation mode: - the evacuation route should be short and direct - the number of bends in the pipes should be minimal - the path of the pipes should contain bends rather than sharp angles - the diameter of the pipes should be as large as possible, preferably the same diameter as the evacuation opening. Installing the hood Failure to follow these basic rules will lead to significant loss of power and an increase in noise level. If these rules are not followed, the warranty will be voided. 2) Before the installation of the hood, please remove the security piece you can see in the picture 1-2-3-4. 3) Make a rectangular opening, 790 x 100 mm in size, in the back of the cook top. 4) For models with motor already fitted, remove the screws and the extraction unit to fit the hood in the relevant hole. At this point, insert a seal (silicone) in the bottom section of the frame support (Fig. 5) and place in the relevant hole (Fig. 6-7), then proceed to insert the hood into the unit. 5)If you would like to place the hood very close to cooktop, connect the opening of the hood to the one of the cooktop. In this case, it is no longer necessary to remove the motor. 6) Before making the opening, check that there are no structural or other parts inside the cabinet, where the appliance is to be placed, which could hinder a proper installation. Check that the dimensions of the hood and the ones of the cooktop are compatible with the cabinet so that the installation can be carried out properly. 7) Put the hood in the opening, inserting it from above as shown in Fig. 8) The upper edge of the hood must fit perfectly the cooktop. According to the dimensions of the cabinet and of the air outlet duct, use the provided fixing brackets. [. . . ] We cannot be held responsible for any incident or accident caused by a nonconforming electrical connection or a non-existent or defective ground. Failure to follow the instructions for cleaning the appliance and filters may cause fires. This appliance must be cleaned regularly. never use a scouring pad , or abrasive or caustic products. [. . . ]