User manual AEG-ELECTROLUX DI9610M-R

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual AEG-ELECTROLUX DI9610M-R. We hope that this AEG-ELECTROLUX DI9610M-R user guide will be useful to you.

Lastmanuals help download the user guide AEG-ELECTROLUX DI9610M-R.


Mode d'emploi AEG-ELECTROLUX DI9610M-R
Download
Manual abstract: user guide AEG-ELECTROLUX DI9610M-R

Detailed instructions for use are in the User's Guide.

[. . . ] in this case the hood will be slightly noisier. Attention: The hose is not supplied and must be purchased separately. The minimum distance between the supporting surface for the cooking vessels on the hob and the lowest part of the range hood must be not less than 50cm from electric cookers and 65cm from gas or mixed cookers. If the instructions for installation for the gas hob specify a greater distance, this must be adhered to. [. . . ] This operation is necessary after approximately 160 working hours. After cleaning or replacing the filters, press button 3 for 3 seconds until the grease filter LED F or the charcoal filter LED C stops flashing. Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. The perimeter air suction panels are attached to the cooker hood by a series of pins and coupling springs; pull them outwards and detach them from the fastening cable. 3 Clean the perimeter air suction panels as often as the grease filters (for more information about gentle cleaning methods, read the paragraph "Cleaning" in the pages that follow). when refitting the perimeter air suction panels , ALWAYS reattach the fastening cables. Make sure the panels are attached to the cooker hood properly (snapfastened). The inner crosspiece should be removed in order to access the grease filters and the inside of the cooker hood (for example: when performing maintenance work on the carbon filters). to remove it (depending on the model) , proceed as follows: Warning!Keep the crosspiece supported during removal/fitting procedures, in order to prevent it from falling and damaging other objects. Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the rating plate located on the inside of the unit. The charcoal filter can be ordered from your local Service Force Centre. You are therefore strongly recommended to follow these instructions. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Prior to touching the light bulbs ensure they are cooled down. Extract the lamp cover by using a small flat screwdriver or similar tool as a lever. Replace the old bulb with a new one of the same type. If the light does not come on, make sure the bulb has been inserted in correctly before contacting your local Service Force Centre. Clean the outside of the hood using a damp cloth and a solution of water and mild washing up liquid. Only ever clean the switch panel and filter grill using a damp cloth and mild washing up liquid. [. . . ] The tube should be fitted to the ceiling E (mm)-180 as an exhaust system to expel fumes outside; the visible part should be 180 mm shorter than the structural support (please refer to measurement E calculated previously). Install the structure to the ceiling, onto the 4 pretightened screws and then screw them in firmly. For the recirculation mode only: assemble the three parts of the deflector (central part + 2 extensions) using 2 screws so that once assembled, the deflector is the same width as the structural support. Fasten the deflector inside the structural support using 4 screws. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE AEG-ELECTROLUX DI9610M-R

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual AEG-ELECTROLUX DI9610M-R will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag