User manual AEG-ELECTROLUX DI9893-M

[. . . ] La distance minimum entre la superficie de support des récipients sur le dispositif de cuisson et la partie la plus basse de la hotte de cuisine ne doit pas être inférieure à 50cm dans le cas de cuisinières électriques et de 65cm dans le cas de cuisinières à gaz ou mixtes. Assemblez les deux parties de cheminée supérieure (P+Q) à la structure support de hotte selon le schéma d'assemblage (voir figure ci-contre). When used as an extractor unit, the hood must be fitted with a hose having preferably the same diameter as the outlet hole. Should there already be a pipe of diameter 125 mm that ducts to the outside through the walls or roof, it is possible to use the 150/125 mm reduction flange provided. [. . . ] The inner crosspiece should be removed in order to access the grease filters and the inside of the cooker hood (for example: when performing maintenance work on the carbon filters). to remove it (depending on the model) , proceed as follows: Warning!Keep the crosspiece supported during removal/fitting procedures, in order to prevent it from falling and damaging other objects. Remove it from its position using the spring release system. Re-fit the crosspieces by carrying out the above steps in reverse. Make sure the crosspiece is fixed to the cooker hood properly. The purpose of the grease filters is to absorb grease particles which form during cooking and it must always be used, either in the external extraction or internal re-circulation function. Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. removing the metal grease filters · Push it towards the back of the unit and then pull it down and out. Hand washing Soak grease filters for about one hour in hot water with a greaseloosening cleaner, then rinse off thoroughly with hot water. Refit the grease filters when they are dry. dishwasher Place grease filters in the dishwasher. Select most powerful washing programme and highest temperature, at least 65°C. Refit the grease filters when they are dry. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance. Clean the inner housing using a hand hot solution only(never use caustic detergents, abrasive powders or brushes). The charcoal filter should only be used if you want to use the hood in recirculation mode. Cleaning/replacing the carbon filter Unlike other carbon filters, the LONGLIFE carbon filter can be cleaned and reactivated. At normal use the filter should be cleaned every second month (when using the hood 2, 5 hours per day, in avarage). The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest temperature (65º C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. [. . . ] fit an exhaust tube to the deflector connection ring. The tube must be 300 mm shorter in length than the structural support (please refer to measurement E calculated previously). Carry out the necessary electrical connection. Fix the nuts in place with the couplings both on the upper internal sections of the flues (P+Q) and on the lower back section of the flues (R). [. . . ]