User manual AEG-ELECTROLUX DI9966-M

[. . . ] Never use the hood for purposes other than for which it has ben designed. Never leave high naked flames under the hood when it is in operation. Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. [. . . ] Lift up the frame, fit the frame slots onto the screws up to the slot end positions. Tighten the two screws and fasten the other two screws provided; before locking the screws completely, it is possible to adjust the frame by turning it, making sure that the screws do not come out of their housing in the adjustment slot. It is now possible to place and tighten the 4 safety screws, Proceed as follows: · Drill the ceiling with a 10 mm ø bit taking as reference the holes of the side parts of the upper chimney fixing part. The Frame must be securely fastened so as to support both the weight of the Hood and the stress caused by occasional axial pressure against the fitted Appliance. After fixing, make sure that the base is stable even when the Frame is subjected to lateral stress. If the Ceiling is not strong enough in the area where the hood is to be fixed, the Installer must strengthen the area using suitable plates and counterplates anchored to resistant structures. When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. Fix the pipe using the pipe clamps 25 (not provided). Attach the adhesive Novastik gasket 13 to the air outlet connection 15 and fix this to the upper frame using the 2 knobs 24. Fix the air outlet connection extension piece 14 to the air outlet connection 15. Place the air outlet connection tube 29 between the two air outlets. Insert the upper duct and fix it on the top of the upper duct connection using the 12c screws (2. It is necessary to make sure that the air outlet connection 15 is placed correctly so that the air outlet grid in it corresponds to that of the chimney. If the grids of the two parts are not corresponding to each other, it will be necessary to remove the chimney and to adjust the position of the air outlet connection 15, and at last to assembly the parts again by following the earlier indications. Before fixing the hood body to the frame: · Screw the 2 screws 12f half way into the holes provided in the sides of the bottom of the frame. Working from below, fix the hood canopy to the frame (B), using the 4 screws 12q and 4 washers 22 provided, then tighten all the screws securely. [. . . ] This cannot be washed or regenerated, and must be changed at least once every 4 months, or when led H starts to flash. The alarm signal only appears when the Suction motor is turned on. Within 5 seconds, press Button H until Led H flashes in confirmation: · Fit the new filter and fasten it in its correct position. [. . . ]