User manual AEG-ELECTROLUX DI9993-M

[. . . ] Do not flambè under the range hood; risk of fire · This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Switch off or unplug the appliance from the mains supply before carrying out any maintenance work. Clean and/or replace the Filters after the specified time period (Fire hazard) · Clean the hood using a damp cloth and a neutral liquid detergent. [. . . ] Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. Ty Product Components 1 Hood Body, complete with: Controls, Light, Blower, Filters 1 Upper Chimney 1 Telescopic frame complete with extractor, consisting of: 1 Upper frame 1 Lower frame 1 Reducer Flange ø 150-120 mm 1 Gasket 1 Hood Body Air Outlet Extension Piece 1 Air Outlet Connection Pipe clamps (not included) 1 Fixing Part of the upper Chimney 1 Air outlet connection tube Q. Dia washers M6 nuts Fixing knobs for the air outlet connection piece Use a plumb line to mark the centre of the hob on the ceiling/support shelf. Place the drilling template 21 provided on the ceiling/support shelf, making sure that the template is in the correct position by lining up the axes of the template with those of the hob. For wooden beam ceilings, drill according to the wood screws used. For the power supply cable feed, drill ø 10 mm. Insert two screws of the following type, crossing them and leaving 4-5 mm from the ceiling: · For concrete ceilings, use the appropriate plugs for the screw size (not provided). For Cavity ceiling with inner space, with wall thickness of approx. For wooden beam ceilings, use 4 wood screws (not provided). Turns the suction motor on and off at the last speed used. LED The LEDs turn on and off according to the speed set. Activates intensive speed from any other speed or with the motor off. This speed is timed to run for 5 minutes, after which the system returns to the previous speed. Activates automatic delayed shutdown of the Motor and the Lighting System after 10' if Speed Three is set, after 15' if Speed Two is set, after 20' if Speed One is set. After 100 Working Hours, Led H lights up Fixed to indicate saturation of the Metal Grease filters After 200 Working Hours, Led H flashes to indicate saturation of the Activated Charcoal Filters. Clean the outside by using a damp cloth and neutral liquid detergent. Clean the inside as well by using a damp cloth and neutral detergent; do not use wet cloths or sponges, or jets of water; do not use abrasive substances. When the above operation has been completed, hook the panel back to the hood canopy and close it by turning the knob in the opposite direction. These can be washed in the dishwasher, and need to be cleaned whenever the H Led comes on or at least once every 2 months use, or more frequently if use is particularly intensive. Remove the filters one by one pushing them towards the back side of the hood unit and simultaneously pulling downwards. [. . . ] Remove the filters one by one pushing them towards the back side of the hood unit and simultaneously pulling downwards. Any kind of bending of the filters has to be avoided when washing them. Before fitting them again into the hood make sure that they are completely dry. (The colour of the filter surface may change throughout the time but this has no influence to the filter efficiency). [. . . ]