User manual AEG-ELECTROLUX DINGO ZAM6107 PORSZI

[. . . ] Once the electric cable has been extended, it stays in that position. 16 To rewind the cable, press the cord rewinder pedal. 17a Start the vacuum cleaner by sliding the power control in the direction of the "Max" position. Increase suction power by sliding the control further up to "Max" position. [. . . ] In order to achieve an optimal cyclone effect in the cleaner, the power regulation should always be in the "Max" position. 17b* Suction power can also be adjusted by using the suction control on the hose handle. 18 Ideal parking position for pausing (18a) and storing (18b). 12 Before starting 11 11 Never vacuum: · In wet areas. · When housing shows visible signs of damage. 13 Never vacuum: 3 4 · Sharp objects, fluids. · Hot or cold cinders, lit cigarette butts, etc. · Fine dust, for example from plaster, concrete, flour, hot or cold ashes. The above may cause serious damage to the motor ­ damage which is not covered by the warranty. Electrical cable precautions: Regularly check that the cable is not damaged. Never use the vacuum cleaner if the cable is damaged. Damage to the machine's cable is not covered by the warranty. 5 6 15 14 16 7 8 17a 17b 9 10 * Certain models only. * Certain models only. 18a 18b Getting the best results Use the nozzles as follows: Carpets: Use the combination floor nozzle with the lever in position (19). Hard floors: Use the combination floor nozzle with the lever in position (0). 19 20 Emptying and cleaning the dust container CycloneXL's dust container must be emptied when it is full. 7 Pull the release button at the rear of the vacuum cleaner. EF H1) · Hepa H1* washable (can be bought as an option, Ref. EF H1W) The filters must always be replaced with new ones and cannot be washed (except the Hepa H1* washable). 7 8 Open the back lid and lift out the filter. Insert a new filter and close the lid. Note: The warranty does not cover any damage to the hose caused by cleaning it. Cleaning the floor nozzle Be sure to frequently clean the combination floor nozzle. * Press each wheel-hub and draw away the wheels. Remove dust-balls, hair or other objects that may be entangled. * Larger objects can be accessed by removing the connection tube from the nozzle. 41 Cleaning the turbo nozzle* 34 Disconnect the nozzle from the vacuum cleaner tube and remove entangled threads, etc. Use the hose handle to clean the nozzle. 35 42 36 43 37 44 * Certain models only. 38 * Certain models only. 8 9 45 Troubleshooting · Check that the cable is connected to the mains. · Check that the plug and cable are not damaged. · Check for a blown fuse. The vacuum cleaner stops · Check whether the dust container is full. · Is the nozzle, tube or hose blocked? [. . . ] · Are the filters blocked? Water has entered the vacuum cleaner Consumer information It will be necessary to replace the motor at an authorised Electrolux service centre. Damage to the motor caused by the penetration of water is not covered by the warranty. Electrolux decline all responsibility for all damages arising from any improper use of the appliance or in cases of tampering with the appliance. This product is designed with the environment in mind. [. . . ]