User manual AEG-ELECTROLUX DINGO ZCX6202 PORSZI

[. . . ] 1 Insert the hose until the catches click to engage (press the catches to release the hose). 1 Attach the extension tubes* or telescopic tube* to the hose handle and nozzle by pushing and twisting together. (Twist and pull apart to dismantle. ) 1 Extend the electric cable and connect it to the mains. [. . . ] Remove lids at both ends and rinse the container in water or machinewash it. Remove particles that may be stuck in the cone. Wooden floors: Use the parquet nozzle* (1). Upholstered furniture and fabrics: Use the upholstery nozzle* () for sofas, curtains, lightweight fabrics etc. Frames, bookshelves, etc. : Use the feather duster* (). Crevices, corners, etc. : Use the crevice nozzle* (). 27 Using the turbo nozzle* 6 21 22 Ideal for carpets and wall-to-wall carpeting to remove stubborn fluff and pet hairs. Adjust the suction power by opening or closing the air vent. 28 Note: Do not use the turbo nozzle on skin rugs or carpet fringes. To avoid damaging the carpet, do not keep the nozzle stationary whilst the brush is rotating. Do not pass the nozzle across electric cables, and be sure to switch off the vacuum cleaner immediately after use. 23 24 29 30 25 26 31 * Certain models only. * Certain models only 32 6 7 Cleaning the motor filter and the dust container filter CycloneXL has a motor filter and a dust container filter that should be cleaned now and then. Open the front lid and lift out the dust container. Dust container filter: Remove the filter holder from the dust container and carefully pull the dirty dust container filter out of the holder. Motor filter: Pull the filter upwards until coming away from the groove. 6 Rinse the filters in lukewarm water and let them dry. Replace the dust container and then close the lid. Cleaning the hose and nozzle The vacuum cleaner stops automatically if the nozzle, tube, hose or filters become blocked and when the dust container is full. In such cases, disconnect from mains and allow to cool for 0-0 minutes. Clear blockage and/or replace filters, empty the dust container and restart. Tubes and hoses 9 0 1 Use a cleaning strip or similar to clear the tubes and hose. Hose handle could be dismantled from hose if cleaning is needed. [. . . ] For details see our web site: www. electroluc. com If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified person in order to avoid a hazard. Young children should be supervised to ensure that they do not play with the appliance. Close attention is necessary when used near children. [. . . ]