User manual AEG-ELECTROLUX DK1160-M

[. . . ] When installing the hood, make sure you respect the following minimum distance from the top edge of the cooking hob/ring surfaces: electric cookers 600 mm gas cookers 700 mm coal and oil cookers 800 mm min. The hood can be installed above these heights but for optimum performance it should be installed at the distance quoted for the appropriate heat source. The national decree on fuel-burning systems specifies a maximum depression of 0. 04 bar in such rooms. The air outlet must not be connected to chimney flues or combustion gas ducts. [. . . ] Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. Open the metal grease filter Push it towards the back of the unit and then pull it down and out. Fig. 4. Hand washing Soak grease filters for about one hour in hot water with a grease-loosening cleaner, then rinse off thoroughly with hot water. Refit the grease filters when it are dry. Fig. 4 Dishwasher machine Place grease filters in dish washer. Select most powerful washing programme and highest temperature, at least 65°C. Refit the grease filters when it are dry. When washing the metal grease filter in the dishwasher a slight discoloration of the filter can occur, this does not have any impact on its performance. Clean the inner housing using a hot detergent solution only (never use caustic detergents, abrasive powders or brushes). 70 Carbon filter The carbon filter should only be used if you want to use the hood in its filtering function. To do this you will need an original AEG activated carbon filter (see special accessories). This filter cannot be cleaned or reused. As a general rule, the activated carbon filter should be changed once every four months. 5 Fit one carbon filter on the left and one on the right so to cover the plastic grids that protect the fan wheel, then turn clockwise the central handle of the carbon filter. Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the registration plate located on the inside of the unit. The activated carbon filters can be ordered from the AEG technical assistance service. Fig. 5 71 Warning Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulb Disconnect the cooker hood from the main supply. Replace the old bulb with a new one of the same type. If the light does not come on, make sure the bulb has been inserted in correctly before contacting the technical assistance service. Fig. 6 72 Cleaning Warning: always disconnect the hood from the mains power supply before cleaning it. Never insert pointed objects in the motors protective grid. [. . . ] - The product is installed and used in accordance with our instructions and is only used domestically, i. e. - The product is installed taking into account regulations in your new country. 74 Before you move please contact your nearest Customer Care Centre, listed below, to give them details of your new home. They will then ensure that the local Service Organisation is aware of your move and able to look after you and your appliances. Prepare the electric connection (14) (see relative chapter). Fit the chimney (15) and fix it on the chimney support with two screws 3, 0 x 9 mm (16). [. . . ]