User manual AEG-ELECTROLUX DK4490-M

[. . . ] Before any cleaning or maintenance operation, disconnect hood from the mains by removing the plug or disconnecting the mains electrical supply. Always wear work gloves for all installation and maintenance operations. The appliance is not intended for use by children or persons with impaired physical, sensorial or mental faculties, or if lacking in experience or knowledge, unless they are under supervision or have been trained in the use of the appliance by a person responsible for their safety. This appliance is designed to be operated by adults, children should be monitored to ensure that they do not play with the appliance. [. . . ] Press button 2 to deactivate this function before the set time expires; the hood will adjust to speed 1. Speed timer button Press button "4" to activate the speed timer; the hood turns off once the set time expires. the timer functions in the following way: · Speed 1 - 20 minutes (the number "1" and a small flashing LED light appear on the display) · Speed 2 - 15 minutes (the number "2" and a small flashing LED light appear on the display) · Speed 3 - 10 minutes (the number "3" and a small flashing LED light appear on the display) · High-speed - 5 minutes (the number "4" and a small flashing LED light appear on the display) Press button 1 or button 4 to turn the hood off while the speed timer is in function; by pressing button 2, the hood returns to the set speed. Grease filter indicator After 80 hours of operation, the number "1" starts flashing on the display. press and hold button 1 or 3 to reset the indicator. Carry out maintenance on the grease filter according to the indications of this manual. Charcoal filter indicator After 320 hours of operation, the number "2" starts flashing on the display. press and hold button 1 or 3 to reset the indicator. Carry out maintenance on the charcoal filter according to the indications of this manual. When both filter signals appear simultaneously, numbers "1" and "2" will alternately flash on the display. reset the indicator by performing the above-mentioned procedure twice. The first operation resets the grease filter indicator, while the second operation resets the charcoal filter indicator. the charcoal filter indicator is not active in the standard mode. If the hood is used in the recirculation mode, the charcoal filter indicator must be activated. Perform the following steps to activate the charcoal filter indicator: Turn the hood off and keep buttons 2 and 3 pressed for 3". The numbers "1" and "2" will flash for 2" once the function has been activated. Charcoal filter indicator deactivation: Turn the hood off and keep buttons 1 and 2 pressed for 3". Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket. The purpose of the grease filters is to absorb grease particles which form during cooking and it must always be used, either in the external extraction or internal re-circulation function. Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. Hand washing Soak grease filters for about one hour in hot water with a greaseloosening cleaner, then rinse off thoroughly with hot water. [. . . ] ) This information is shown on the registration plate inside the unit behind the grease filter. Safety warnings for the electrician The mains power supply must correspond to the rating indicated on the plate situated inside the hood. Fix the box to the motor unit using the 2 screws that were previously removed. Insert the power supply cable into the electronic box and carry out the electrical connection. [. . . ]