User manual AEG-ELECTROLUX DK9190-M

[. . . ] DK DK DK DK DK HC 9160-9190 9360-9390 9660-9690 9960-9990 9090-9060 5690-3360 Dunstabzugshaube Afzuigkap Hotte Cooker Hood Montage- und Gebrauchsanweisung Installatie- en gebruiksaanwijzing Notice dutilisation et dinstallation Operating and Installation Instructions Contents Safety warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 67 For the user . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 67 For the installer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 68 Description of the Appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] The control switches are located on the hoods front panel: DK 9090 D - 9060 D the light switch switches the hood lamp on and off the Electr. valve switch serves to open (and close) the electrical valve so to let air be extracted towards the outside. Light switch Electr. valve switch DK 9160 D - 9190 D the light switch switches the hood lamp on and off the motor switch switches the motor on and off, enabling you to select one of the three different speeds. Light switch Motor switch 71 DK 9360 - DK 9390 - HC 3360 the light switch switches the hood lamp on and off the motor switch switches the motor off Speed 1: Speed 1 push-button Speed 2: Speed 2 push-button Speed 3: Speed 3 push-button Light switch Motor switch Speed 1 Speed 2 Speed 3 72 DK 9660 - DK 9690 - HC 5690 AOFF ON push button Press once or more to obtain the function desired: ON: the hood switches on to the last speed selected. OFF: all the functions are switched off except the illumination. Speed selection push button (extraction power). Press this push button once or more to select the most suitable extraction speed (power) (1-2-3). The display shows the extraction power selected, signalling the saturation of the filters (F). The Intensive speed runs for 5 minutes: If the hood is on when the Intensive speed is activated, the hood reverts to previous speed after 5 minutes. If the hood is off when the Intensive speed is activated, the hood will be turned off after 5 minutes. To interrupt the Intensive speed, press button A or B. Light ON/OFF BCD- E- i A B C D E Should the hood or the controls fail to operate: disconnect the power supply for at least 5 seconds, then turn the hood back on again. 73 DK 9960 - DK 9990 SENSOR A A- B C D E ON (stand-by - illuminated key) / OFF push button. Press once or more to obtain the function desired: Stand-by (illuminated push button): the hood is ready to function, the safety procedure is activated (see under safety procedure). OFF: all the functions are switched off except the illumination. B - Speed selection push button (extraction power). Press this push button once or more to select the most suitable extraction speed (power) (1-2-3-i). On delivery, the hood is not supplied with a charcoal filter, so the saturation indicator will be disabled. If the hood is to be used with a charcoal filter, the saturation indicator light must be enabled as follows: DK 9660 - DK 9690 - HC 5690: Set the hood in OFF. Pressing keys B and D simultaneously for three seconds, LED F lights up and begins to flash the 1st speed led. After 1 second the 2nd speed led also flashes and the system emits a sound signal (-Beep-) to indicate setting taking place. To remove the charcoal filter signal press push buttons B and D simultaneously for 3 seconds. LED F lights up and begins to flash the 1st speed led (grease filter) and the 2nd speed led. After 1 second, only the 1st speed led continues to flash. [. . . ] 83 Length of the cable 180cm 180cm 150cm 150cm 150cm 150cm 150cm 150cm 150cm 150cm Electrical connection (not for UK) Safety warnings for the electrician Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. Should it be necessary to provide a fixed connection, the hood must only be installed by an electrician authorised by the local electricity board. When installing, an omnipolar disconnector with a distance of at least 3 mm between contacts must be provided. [. . . ]