User manual AEG-ELECTROLUX DK9660-MR

[. . . ] When used as an extractor unit, the hood must be fitted with a hose having preferably the same diameter as the outlet hole. Should there already be a hose of diameter 125 mm that ducts to the outside through the walls or roof, it is possible to use the 150/125 mm reduction flange provided. In this case the hood will be slightly more noisy. Attention: The hose is not supplied and must be purchased separately. [. . . ] Turn the hood on a few minutes before you start cooking. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The cooker hood is fitted with a sensor which, in the event of extreme variations in temperature, switches the appliance on automatically until the temperature of the environment surrounding the hood has been significantly reduced. The control switches are located on the unit's front panel: 1 Motor ON/OFF button By pressing the button, the hood starts at speed 1. Pressing the button (OFF) while the hood is in function turns the latter off. 2 Speed increase button By pressing the button, the hood starts at speed 1. Pressing the button (while the hood is on) modifies the motor speed: Speed 1: the number "1" appears on the display Speed 2: the number "2" appears on the display Speed 3: the number "3" appears on the display High-speed: the number "4" appears (flashing) on the display The high-speed function is regulated by a timer. The standard time setting is 5', at the end of which the hood adjusts to speed 2. Press button 2 to deactivate this function before the set time expires; the hood will adjust to speed 1. Speed timer button Press button "4" to activate the speed timer; the hood turns off once the set time expires. the timer functions in the following way: · Speed 1 - 20 minutes (the number "1" and a small flashing LED light appear on the display) · Speed 2 - 15 minutes (the number "2" and a small flashing LED light appear on the display) · Speed 3 - 10 minutes (the number "3" and a small flashing LED light appear on the display) · High-speed - 5 minutes (the number "4" and a small flashing LED light appear on the display) Press button 1 or button 4 to turn the hood off while the speed timer is in function; by pressing button 2, the hood returns to the set speed. Refit the grease filters when they are dry. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance. The charcoal filter should only be used if you want to use the hood in recirculation mode. To do this you will need an original charcoal filter (available from your local Service Force Centre). Replacing the charcoal filter The charcoal filter cannot be washed nor regenerated. The charcoal filter should be replaced every 4 months under normal use. Replacement filters are available from your local Service Force Centre. Fitting Position the carbon filter inside the hood to cover the protection grill of the motor. Always specify the hood model number, serial number and product number code when ordering replacement filters. This information is shown on the rating plate located on the inside of the unit. The charcoal filter can be ordered from your local Service Force Centre. [. . . ] Check that a fan speed has been selected Check that: The fan speed is set high enough for the task. The kitchen is adequately vented to allow the entry of fresh air. Turn off the hob and then wait for the device to reset. If the hood has been installed below the heights indicated in the installation instructions the motor will cut-out frequently which will damage the hood. [. . . ]