User manual AEG-ELECTROLUX DK9660M-CH

[. . . ] DK 9660 DK 9690 Dunstabzugshaube Hotte Cappa aspirante Cooker Hood Montage- und Gebrauchsanweisung Notice dutilisation et dinstallation Istruzioni di montaggio e uso Operating and Installation Instructions Contents Safety warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 54 For the user . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 54 For the installer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 54 Description of the Appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] In this case the hood will be slightly noisier. Recirculation mode The air is filtered through a charcoal filter and returned to the kitchen. You will need an original charcoal filter for the recirculation mode. Fix the deflector using 2 screws Ø 2, 9x13 mm. Optionally, the position of the chimney elements can be changed. When using the hood in the recirculation mode the chimney must be fixed at the top, with the air outlet grill at the side. 2 56 Control Panel Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the units front panel: AOFF ON push button Press once or more to obtain the function desired: ON: the hood switches on to the last speed selected. OFF: all the functions are switched off except the illumination. Speed selection push button (extraction power). Press this push button once or more to select the most suitable extraction speed (power) (1-2-3). The display shows the extraction power selected, signalling the saturation of the filters (F). The Intensive speed runs for 5 minutes: If the hood is on when the Intensive speed is activated, the hood reverts to previous speed after 5 minutes. If the hood is off when the Intensive speed is activated, the hood will be turned off after 5 minutes. To interrupt the Intensive speed, press button A or B. Light ON/OFF BCD- E- i A B C D E Should the hood or the controls fail to operate: disconnect the power supply for at least 5 seconds, then turn the hood back on again. 57 Grease and charcoal filter maintenance indicator This hood is fitted with a device that indicates when it is necessary to clean the grease filter or the charcoal filter (if the hood is used in the recirculation version with a charcoal filter). On delivery, the hood is not supplied with a charcoal filter, so the saturation indicator will be disabled. If the hood is to be used with a charcoal filter, the saturation indicator light must be enabled as follows: Set the hood in OFF. Pressing keys B and D simultaneously for three seconds, LED F lights up and begins to flash the 1st speed led. After 1 second the 2nd speed led also flashes and the system emits a sound signal (-Beep-) to indicate setting taking place. To remove the charcoal filter signal press push buttons B and D simultaneously for 3 seconds. [. . . ] We reserve the right to change specifications and colours as a result of our policy of continuing technological development. 63 Technical Details Dimensions (in cm): Height Width Depth Maximum absorbed power: Motor absorption: Lighting*: Length of the cable: Electrical connection: DK 9660 80-135 59, 8 47 290 W 250 W 2 x 20W (G4) 150cm 220-240 V DK 9690 82-137 89, 8 48 290 W 250 W 2 x 20W (G4) 150 cm 220-240 V Mounting accessories included 6 wall plugs Ø 8 mm (brick fixing only) 6 wood-screws 5 x 45 mm 2 metal screws 2, 9 x 13 4 metal screws 2, 9 x 6, 5 5 metal screws 3, 5 x 9, 5 2 hooks 1 chimney support 2 clamps 1 deflector 1 reduction flange Ø 150-125 mm 1 charcoal filter frame 1 allen spanner 64 Electrical connection (not for UK) Safety warnings for the electrician Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. Should it be necessary to provide a fixed connection, the hood must only be installed by an electrician authorised by the local electricity board. When installing, an omnipolar disconnector with a distance of at least 3 mm between contacts must be provided. [. . . ]