User manual AEG-ELECTROLUX DK9690M/CH

[. . . ] It is very important to clean the hood and replace the filter at the recommended intervals. Failure to do so could cause grease deposits to build up, resulting in a fire hazard. The appliance is not intended for use by young children or infirm persons without supervision. Older children must be supervised if using the appliance. [. . . ] The display shows the extraction power selected, signalling the saturation of the filters (F). The Intensive speed runs for 5 minutes: If the hood is on when the Intensive speed is activated, the hood reverts to previous speed after 5 minutes. If the hood is off when the Intensive speed is activated, the hood will be turned off after 5 minutes. Should the hood or the controls fail to operate: disconnect the power supply for at least 5 seconds, then turn the hood back on again. This hood is fitted with a device that indicates when it is necessary to clean the grease filter or the charcoal filter (if the hood is used in the recirculation version with a charcoal filter). On delivery, the hood is not supplied with a charcoal filter, so the saturation indicator will be disabled. If the hood is to be used with a charcoal filter, the saturation indicator light must be enabled as follows: Pressing keys B and D simultaneously for three seconds, LED F lights up and begins to flash the 1st speed led. After 1 second the 2nd speed led also flashes and the system emits a sound signal (-Beep-) to indicate setting taking place. to remove the charcoal filter signal press push buttons B and D simultaneously for 3 seconds. LED F lights up and begins to flash the 1st speed led (grease filter) and the 2nd speed led. After 1 second, only the 1st speed led continues to flash. The system emits a sound signal (-Beep-) to indicate setting taking place. Grease filter LED The 1st speed led (+ led F) flashes, when it is time to clean the grease filter. Always comply with the maintenance instructions for the grease filter. Charcoal filter LED The 2nd speed led (+ led F) flashes, when the charcoal filter needs to be cleaned or replaced. Resetting the saturation indicator After cleaning or replacing the filters, press button 1 for 3 seconds until the 1st speed led or the second speed led stops flashing. The resetting of the saturation indicator MUST be done in stand-by, never disconnect the hood from the mains. The hood must always be disconnected from the electricity supply before beginning any maintenance work. Clean the outside of the hood using a damp cloth and a solution of water and mild washing up liquid. Only ever clean the switch panel and filter grill using a damp cloth and mild washing up liquid. It is extremely important to clean the unit and change the filters at the recommended intervals. Failure to do so will cause grease deposits to build up that could constitute a fire hazard. [. . . ] If after all these checks, the problem persists, contact your local Service Force Centre, quoting the model and serial number. Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. You are welcome to telephone our technical assistance service (see list of technical assistance centres) whenever you need information or in the unlikely event of a fault. [. . . ]