User manual AEG-ELECTROLUX DL6250ML-S

[. . . ] Technical data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 47 48 49 50 53 55 55 Safety instructions This appliance is to be used solely as a household appliance. It has been manufactured according to the international safety and quality standards. [. . . ] To remove the filters: · Press the handle Q that locks the grease filter N first towards the opposite side and then extract downwards. The filter is made of aluminium wires on which the grease collects. Clean the filter in hot water using a detergent, or in a dishwasher. Let the filter dry before putting it back. Note that a dishwasher may discolour the filter. 3 Carbon filter · The activated carbon filter should only be used if you want to use the hood in its filtering function. · To do this you will need an original AEG activated carbon filter (see special accessories). · The carbon filters absorb smells and odours. 50 · Changing and cleaning the carbon filter - KF 8 Unlike other carbon filters, the LONGLIFE carbon filter can be cleaned and reactivated. At normal use the filter should be cleaned every second month. The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest temperature (65º C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. To reactivate the carbon, the filter should be dried in an oven for 10 minutes with a temperature of maximum 100º C. After approximately three years of use, the KF8 filter should be replaced with a new, as the odour reduction capacity will be reduced. · Replacing the carbon filter - KFL 6080 The activated carbon filter must normally be replaced at least once every year. This filter cannot be washed or regenerated. To guarantee proper absorption of odours the working volume of the activated carbon must be proportionate to the hood air flow. In this case the high quality of the activated carbon will ensure efficient odour removal for approximately one year, assuming that the hood is used normally. For this reason you should always use original AEG filters only, making sure they are replaced when necessary. · Mounting Remove the grease filter. Apply active carbon filter KLF 60/80, special accessory E-Nr. :610 899 421 on the lamp side, press in both red lugs on the carbon filter, and unclip the carbon filter forwards (towards the front edge of the appliance). [. . . ] · Replace the grease filter. 56 Fig. 9. 1 3-F OK! 5-C 4 5-C OK! 6 6 7 7 7 7 2 Fig. 6 57 Removing the hood from cabinet Follow these steps: · Remove the grease filter. · Remove the 4 additional screws from the frame. [. . . ]