User manual AEG-ELECTROLUX DU 4360

[. . . ] The cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. Always cover lighted elements, to prevent excess heat from damaging the appliance. In the case of oil, gas and coal fired cookers it is essential to avoid open flames. Also, when frying, keep the deep frying pan on the cooker top/cooker under careful control. [. . . ] Press this push button once or more to select the most suitable extraction speed (power) (1-2-3). The display shows the extraction power selected, signalling the saturation of the filters (F). The Intensive speed runs for 5 minutes: If the hood is on when the Intensive speed is activated, the hood reverts to previous speed after 5 minutes. If the hood is off when the Intensive speed is activated, the hood will be turned off after 5 minutes. Should the hood or the controls fail to operate: disconnect the power supply for at least 5 seconds, then turn the hood back on again. This hood is fitted with a device that indicates when it is necessary to clean the grease filter or the charcoal filter (if the hood is used in the recirculation version with a charcoal filter). On delivery, the hood is not supplied with a charcoal filter, so the saturation indicator will be disabled. If the hood is to be used with a charcoal filter, the saturation indicator light must be enabled as follows: Set the hood in OFF. Pressing keys B and D simultaneously for three seconds, LED F lights up and begins to flash the 1st speed led. After 1 second the 2nd speed led also flashes and the system emits a sound signal (-Beep-) to indicate setting taking place. to remove the charcoal filter signal press push buttons B and D simultaneously for 3 seconds. LED F lights up and begins to flash the 1st speed led (grease filter) and the 2nd speed led. After 1 second, only the 1st speed led continues to flash. The system emits a sound signal (-Beep-) to indicate setting taking place. Grease filter LED The 1st speed led (+ led F) flashes, when it is time to clean the grease filter. Always comply with the maintenance instructions for the grease filter. Charcoal filter LED The 2nd speed led (+ led F) flashes, when the charcoal filter needs to be cleaned or replaced. Resetting the saturation indicator After cleaning or replacing the filters, press button 1 for 3 seconds until the 1st speed led or the second speed led stops flashing. The hood must always be disconnected from the electricity supply before beginning any maintenance work. Clean the outside of the hood using a damp cloth and a solution of water and mild washing up liquid. Only ever clean the switch panel and filter grill using a damp cloth and mild washing up liquid. It is extremely important to clean the unit and change the filters at the recommended intervals. [. . . ] Help us to help you Please determine your type of enquiry before writing or telephoning. When you contact us we need to know: Your name Clear and concise details of the fault Address and post code Name and model of the appliance* Telephone number E number* Serial number* * This information can be found on the rating plate, which can be seen when the grease filters are removed. If you require Customer Service in the Republic of Ireland please contact us at the address below: AEG Electrolux Group (Ire) Ltd Long Mile Road Dublin 12 Republic of Ireland Tel: + 353 (0) 1 4090751 Email: service. For general enquiries concerning your AEG appliance or for further information on AEG products, please contact our Customer Care Department by letter or telephone at the address below or visit our website at www. [. . . ]