User manual AEG-ELECTROLUX DU4190M/UE

[. . . ] Failure to do so could cause grease deposits to build up, resulting in a fire hazard. The appliance is not intended for use by young children or infirm persons without supervision. Older children must be supervised if using the appliance. Young children should be supervised to ensure that they do not play with the appliance. [. . . ] The control switches are located on the hoods front panel: The light switch switches the hood lamp on and off the motor switch switches the motor on and off, enabling you to select one of the three different speeds. The hood must always be disconnected from the electricity supply before beginning any maintenance work. Clean the outside of the hood using a damp cloth and a solution of water and mild washing up liquid. Only ever clean the switch panel and filter grill using a damp cloth and mild washing up liquid. It is extremely important to clean the unit and change the filters at the recommended intervals. Failure to do so will cause grease deposits to build up that could constitute a fire hazard. The purpose of the grease filters is to absorb grease particles which form during cooking and it must always be used, either in the external extraction or internal re-circulation function. Attention: the metal grease filters must be removed and washed, either by hand or in the dishwasher, every four weeks. First, push the metal grease filter stop backwards, then extract the filter, pulling downwards. Hand washing Soak grease filters for about one hour in hot water with a grease-loosening cleaner, then rinse off thoroughly with hot water. Refit the grease filters when they are dry. 4 Select most powerful washing programme and highest temperature, at least 65°C. Refit the grease filters when they are dry. When washing the metal grease filter in the dishwasher a slight discolouration of the filter can occur, this does not have any impact on its performance. Clean the inner housing using a hand hot solution only(never use caustic detergents, abrasive powders or brushes). The charcoal filter should only be used if you want to use the hood in recirculation mode. To do this you will need an original charcoal filter (available from your local Service Force Centre). Replacing the charcoal filter The charcoal filter cannot be washed nor regenerated. The charcoal filter should be replaced every 4 months under normal use. Replacement filters are available from your local Service Force Centre. Fitting Remove the cover by rotating the knobs to 90°, put the charcoal filter inside and fix it by rotating the knob to 90° then close the cover. Always specify the hood model code number and serial number when ordering replacement filters. [. . . ] Make the holes on the bottom of the cupboard (2), using the drilling template (1). Make a hole for the exhaust pipe (4) if the hood is to be used in the extraction version (3). From inside the cupboard, insert the 4 supplied screws (5) and tighten them in the appropriate holes on the appliance. Make 3 Ø 8mm holes in the wall (3), 2 at upper points, 1 as desired at lower points. [. . . ]