User manual AEG-ELECTROLUX E1000

[. . . ] The voltage for both the hotplates and the refrigerator is 230 - 240 V. ASSEMBLING First unpack the base unit and position in front of the place of installation and provide space around it for assembly. Check that the electrical connections have been prepared prior to the installation. [. . . ] The six transport screws which you saved (no. 2) should be used to attach both of the side rails to the sink unit. In order to do this, use a metall drill with 2, 5 mm diameter and drill through the pre bored holes in the side edge profiles through onto the kitchen sink´s side gables. Remove the safety metal bar profile that is fitted between the inner sides of the top unit at the lower front edge and re-mount the screws. FINAL ASSEMBLY · Re-hang the doors and if needed, adjust the hinges. · Connect the plugs in the right wall sockets and test all functions. · Check that the safety micro switch cuts the circuit to the lighting and the hotplates but not to the refrigerator. · Connect water and run through to check seals are tight. SAFETY INSTRUCTIONS The compact kitchen is approved by SEMKO for connection according to the enclosed instructions. The hotplates effect 1000 W respectively 1200 W may not be increased by exchange. The top unit has a safety switch for the hotplates and light / socket assembly. The safety switch closes the circuit when the door is shut and may not be bypassed. 822 90 22-44/rev I ELECTRICAL INSTRUCTIONS HIDEAWAY MINI-KITCHEN WITH HOTPLATES 1. 13 amp sockets are required for the base unit. 13 amp socket is required for the top unit. (An additional 13-amp socket may also be required for a microwave housed within the top unit). The 2 wires located at the back of the top cupboard unit must be connected to the control box located under the sink (behind the controls for the hotplates). This ensures that the circuit to the hotplates is cut off when the upper doors are closed. The blue wire already connected to the terminal block (in the control box), must be moved over by one, to allow the two additional wires from the top unit to be connected. The microwave can be connected to the light / socket switch or alternatively the lead can be taken through the back of the top unit and connected to an additional 13 amp socket. [. . . ] The 13 amp plug from the top unit must be connected to a separate socket from the base unit, which includes the fridge and hotplates, or any other appliance. Do not use 2/3 way connectors or gang sockets. The top unit should not be connected to the same phase as the base unit. Wiring diagram for connecting the top cupboard to a base unit fitted with hotplates. TOP DIAGRAM A Showing existing connections to be found in the control box situated behind the hotplate knobs on the base unit. BOTTOM DIAGRAM B Showing the spiral hose with 2 wires located at the rear of the top cupboard. [. . . ]