User manual AEG-ELECTROLUX EA0302

[. . . ] Wherever possible the back of the product should be close to a wall but leaving the required distance for ventilation as stated in the installation instructions. Before defrosting, cleaning or maintenance work is carried out, be sure to switch off the appliance and unplug it. DO NOT USE SHARP INSTRUMENTS to scrape off frost or ice. Under no circumstances should solid ice be forced off the cooling fins. [. . . ] It is important that the appliance is not directly exposed to radiated heat (sunlight, radiator, near an oven, etc. ). Figure 2. 4. 1. Installation instructions The refrigerator is equipped with an electrically heated absorption cooling unit which is virtually silent in operation. The fridge is designed for free-standing installation, but can be built-in if the following conditions are complied with to ensure satisfactory operation and maximum cooling efficiency. IMPORTANT Please follow the installation details below carefully Guarantee is valid for products installed as described only. The refrigerator must be level both directions 2. There should be 20mm clearance to the wall 3. Ventilation must be provided as shown in alternatives A, B, C or D (fig 2-3) 4. The ventilation duct must at least measure 105mm x the width of the refrigerator 5. Only the entire cooling unit must project into the duct as shown 6. Air passing through the duct must not be preheated by any source of heat 7. Ventilation grills, if used, must have openings of at least 200cm2 each During installation, please ensure the mains plug is accessible at all times. Figure 3. 5. If we want to switch off the unit, turn the thermostat knob to "0", disconnect the refrigerator from the electricity supply and leave the cabinet door open. After defrosting the cabinet interior should be wiped out with a clean, damp cloth. In the case of increased air humidity, frost may form on the cooling ribs. Should the frost layer attain a thickness of approximately 3 mm, the refrigerator must be defrosted to avoid impairing the performance level. Even if this is not the case, the (**) freezer compartment must be defrosted on a regular basis following heavy ice formation every 2-3 months. This is carried out as follows: Set the thermostat at 0, disconnect at the mains, remove food and ice dish and leave the doors open. Do not expose the refrigerator to external heat and do not attempt to scratch away the frost with sharp objects. The drained water runs in a groove and from there continues along a pipe through the refrigerator's rear panel and into a collection container on the cooling unit, where the water evaporates by itself (fig 5). Should the frost layer become very thick, there is a danger of the collection basin overflowing. In this case the water should be absorbed by a cloth placed under the ribs. The water in the freezer compartment should also be absorbed by a cloth. [. . . ] (Details of the model, product- and serialnumber are to be found on the data label in the top left of the inside compartment. ) This refrigerator is equipped with overheating protection. An authorised service technician can check whether this has been triggered or not. In the event of a fault developing, contact your nearest Service Centre-see local telephone directory. Figure 9. Figure 10. Figure 11. 7 GB 15. Putting into operation Technical data: Model Type Gross volume Mains operation Input Energy consumption Climate class Refrigerant EA 3210 EA 0610, EA 0611 EA 0612, RA 0650 MF20-60 60 liter 220 - 240V (AC) 115W 1. 4 kWh/24h N 525g NH3 +H2O EA 3200 EA 0600 EA 0601 EA 0602 EA 3255 EBP MF20-60 60 liter 220 - 240V (AC) 115W 1, 4 kWh/24h N 540g NH3 +H2O The appliance may only be operated from nominal voltage mains as shown on the data plate. [. . . ]