User manual AEG-ELECTROLUX EA130CH

[. . . ] Dezember 2003 10:47 10 g g Dear Customer, 1 Safety instructions Safety when setting up the appliance · The appliance must be stable when standing. Check that the site at which the appliance is to be installed is even and level. · The appliance may only be connected to a mains supply which has a voltage, electricity type and frequency that complies with the specifications on the rating plate (see underside of the appliance). Please read this instruction manual carefully. Please pay particular attention to the safety instructions. [. . . ] 0 Rinse the filter holder and the filter with warm water. Do not clean the filter holder in the dishwasher! 5. Placing cup(s) underneath (Figure 8) 0 Place one or two cups under the openings in the filter holder (figure 8). 3 If the appliance is not going to be used for a longer period of time, do not screw the filter holder back in. This will increase the life of the seal located on the brew head. 6. Brewing an espresso 0 Switch the water/steam selection switch (figure 1/B) to the symbol . 0 When the appliance has attained its operating temperature, turn the selector dial (figure 1/G) to the symbol . The water will now be forced through the espresso grounds under high pressure. Creating steam/frothing milk (Figures 10, 11) The hot steam can be used to froth milk for a cappuccino or to heat liquids. 1. Switch on the appliance. 0 Place the attachment provided onto the steam nozzle (figure 10). 12 EA150. book Seite 13 Freitag, 5. Dezember 2003 10:47 10 g 0 Switch on the appliance using the on/ off switch (figure 1/A). Wait until the appliance has attained its operating temperature and the orange temperature indicator has gone out (figure 1/D). 0 Switch the water/steam selection switch (figure 1/B) to the symbol . Do not use harsh or scratching cleaning agent. Rinse out the water tank at least once a week in normal rinse water. Clean the 1-cup filter and the 2-cup filter from time to time using a brush. Steam nozzle Remove the attachment from the steam nozzle and rinse the attachment in normal rinse water. Wipe the steam nozzle clean using a damp cloth. You can use the maintenance guide (figure 1/K) to screw off the nozzle head to clean it or decalcify it. Drip grating and drip tray The drip tray must be emptied when the level indicator (figure 1/S) is protruding above the drip grating. 13 EA150. book Seite 14 Freitag, 5. Dezember 2003 10:47 10 g 0 Insert your fingers into the holes in the drip grating. Remove the drip grating and rinse it under running water (figure 12). 0 To empty it, hold the drip tray on both sides and pull it forwards and out of the appliance (figure 13). 0 Remove the plastic attachment with the level indicator and rinse both under running water (figure 14). [. . . ] ­ Set the on / off switch to "off" and remove the plug from the mains socket. ­ Leave the machine to cool for at least 20 minutes. ­ Plug the appliance into the mains again and switch it on. If the appliance still does not work, please contact our Customer Care Department. Technical data · Input supply voltage: 230 v, 50 Hz · Power consumption: 1000 W (See rating plate on the underside of the appliance. ) 2 Disposal Packaging material · Place the packaging cardboard in the waste paper collection. [. . . ]