User manual AEG-ELECTROLUX EA3080

[. . . ] Visit our website for: Get usage advice, brochures, trouble shooter, service information: www. aeg. com Register your product for better service: www. aeg. com/productregistration Buy Accessories, Consumables and Original spare parts for your appliance: www. aeg. com/shop CUSTOMER CARE AND SERVICE We recommend the use of original spare parts. When contacting Service, ensure that you have the following data available. The information can be found on the rating plate. Warning / Caution-Safety information General information and tips Environmental information Subject to change without notice. ENGLISH 3 1. [. . . ] Put the product in the compartment before you start the programme. This is the maximum level for the quantity of liquid additives. Flap for powder or liquid detergent Turn it (up or down) in the correct position to use powder or liquid detergent. Always obey the instructions that you find on the packaging of the detergent products. Check the position of the flap 1. Pull out the detergent dispenser until it stops. Press the lever down to remove the dispenser. 16 www. aeg. com 3. To use powder detergent, turn the flap up. 4. To use liquid detergent, turn the flap down. With the flap in the position DOWN: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid detergent than the limit showed in the flap. – Do not set the delay start function. 5. 6. Measure out the detergent and the fabric conditioner. Carefully close the detergent dispenser. Make sure that the flap does not cause a blockage when you close the drawer. 9. 3 Setting and starting the programme 1. 2. 2. 9. 8 Cancel the delay start 1. Press button 5 again and again until the display shows 0’. The programme starts. 9. 9 Open the door While a programme or the delay start operates, the appliance door is locked. To open the appliance door: 1. Press button 4 . The door lock symbol in the display goes off. Close the appliance door and press button 4 . The programme or the delay start continues. If the temperature and level of the water in the drum are too high, the door lock symbol stays on and you cannot open the door. To open the door do the steps that follow: 1. Make sure that no water is in the drum. To drain the water: If necessary, decrease the spin speed. Press the Start/Pause button 4 . When the programme is completed and the door lock symbol goes off, you can open the door 4. [. . . ] Use the key supplied with the appliance. 11. Pull out the plastic spacers. 28 www. aeg. com 12. Put the plastic caps in the holes. You can find these caps in the user manual bag. – We recommend that you keep the packaging and the transit bolts for when you move the appliance. – If the appliance is delivered in the winter months when there are minus temperatures. [. . . ]