User manual AEG-ELECTROLUX EA3140

[. . . ] Visit our website for: Get usage advice, brochures, trouble shooter, service information: www. aeg. com Register your product for better service: www. aeg. com/productregistration Buy Accessories, Consumables and Original spare parts for your appliance: www. aeg. com/shop CUSTOMER CARE AND SERVICE We recommend the use of original spare parts. When contacting Service, ensure that you have the following data available. The information can be found on the rating plate. Warning / Caution-Safety information General information and tips Environmental information Subject to change without notice. ENGLISH 3 1. [. . . ] Liquid additives compartment (fabric conditioner, starch). Put the product in the compartment before you start the programme. This is the maximum level for the quantity of liquid additives. Put the product in the compartment and set the stain function before you start the programme. Flap for powder or liquid detergent Turn it (up or down) in the correct position to use powder or liquid detergent. 16 www. aeg. com Always obey the instructions that you find on the packaging of the detergent products. Check the position of the flap 1. Pull out the detergent dispenser until it stops. Press the lever down to remove the dispenser. 3. To use powder detergent, turn the flap up. 4. To use liquid detergent, turn the flap down. With the flap in the position DOWN: – Do not use gelatinous or thick liquid detergents. – Do not put more liquid detergent than the limit showed in the flap. – Do not set the delay start function. 5. 6. Measure out the detergent and the fabric conditioner. Carefully close the detergent dispenser. To open the door do the steps that follow: 1. If you deactivate the appliance, it is necessary to set the programme again. 2. 9. 6 Change a function You can change only some functions before they operate. 1. Press button 4 . Change the function set. 9. 7 Set the delay start 1. 9. 10 At the end of programme • The appliance stops automatically. • In the display comes on. Press button 5 again and again until the display shows the number of minutes or hours. The related symbols comes on. 18 www. aeg. com • The indicator of the Start/Pause button 4 goes off. • Press button 1 to deactivate the appliance. After five minutes from the end of the programme, the energy saving function automatically deactivates the appliance. When you activate the appliance again, the display show the end of the last set programme. Turn the programme knob to set a new cycle. • Remove the laundry from the appliance. • Keep the door ajar, to prevent mildew and odours. [. . . ] 8. Remove the polystyrene protection from the bottom. Pull up the appliance in vertical position. 1 2 9. Remove the power supply cable and the drain hose from the hose holders. 10. Use the key supplied with the appliance. 11. Put the plastic caps in the holes. You can find these caps in the user manual bag. ENGLISH 29 WARNING! [. . . ]