User manual AEG-ELECTROLUX EAT 3230

[. . . ] The mains cable is of a special type and is only to be replaced by the Customer Care Department since special tools are required for its replacement. Repairs to this appliance may only be carried out by qualified service engineers. Considerable danger may result from improper repairs. If repairs become necessary, please contact the Customer Care Department or your authorised dealer. [. . . ] it is essential that this information is observed. 0 This symbol guides you step by step through the operation of the appliance. Next to this symbol you will find additional information and practical tips on using the appliance. Tips and information about the economical and environmentally friendly use of the appliance are marked with the clover symbol. A B C D E F G H J K L M N Toasting slot Thermally insulated outer casing Browning control indicator lamp Bread lift button Warm up button with indicator lamp Defrost button with indicator lamp Stop button with indicator lamp Roll rack for crisping up bread rolls (fold down) Button for raising the roll rack Crumb drawer Cord storage (on the underside of the appliance) Rating plate (on the underside of the appliance) Switch to suppress the acoustic signal (on the underside of the appliance) If the appliance is used for purposes other than those intended or used incorrectly, no liability can be accepted for any damage that may be caused. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given initial supervision or instruction concerning use of the appliance by a person responsible for their safety. To move the appliance when warm after use, handle it only by the thermally insulated outer housing. Unplug from the plug socket after use. Do not store or cover the appliance until it has fully cooled down. Do not wrap cord around the cord storage until the appliance has fully cooled down. Packaging material The packaging materials are environmentally friendly and can be recycled. If you want to turn off the acoustic signal permanently, use the slide switch on the underside of the appliance (Figure 1/N and Figure 7). An automatic test is performed on first turning the selector switch from the "0" position. all indicator lamps light briefly and an acoustic signal sounds. Then the selector indicator lights corresponding to the set degree of browning. Use a setting between 1 and 3 when you first start toasting. If the toast is not browned to your liking, set the adjuster lower or higher, higher for example when toasting rye or dark bread. When toasting only 1 slice and also when toasting bread that is no longer fresh, use a slightly lower browning setting. To warm up toasted bread press the warm up button to keep the toast warm and crisp. The electronic toasting time regulator ensures that once a browning setting has been chosen, the results are always the same for the same type of bread. The roll rack will become hot during toasting, do not touch. 0 Fold up the roll rack: Press button (Figure 1/J) down (Figure 3). [. . . ] When the roll rack is used, the maximum browning setting must be no higher than setting 2 . 0 Switch on the toaster using the bread lift button (Figure 1/D). 0 When the toaster has switched off, turn the bread. Never place rolls or bread directly on the toasting slot. [. . . ]