User manual AEG-ELECTROLUX EAW3220

[. . . ] The appliance has to be connected to a properly earthed socket in line with the relevant valid country regulations. Servicing must only be carried out by authorised service personnel. 2. 2 Ammonia is used as the coolant. This is a natural compound which is also present in common household cleaners (1 litre of salmiac cleaner contains up to 200g of ammonia - this is roughly double the amount contained in the cooling unit). If a leak occurs (which can be easily detected due to the unpleasant smell): Switch the device off (pull mains plug, if applicable); Ventilate room thoroughly. [. . . ] If this is not the case, do not connect the device and contact your dealer! If the connection cable is damaged it must be replaced by the Customer Service at Dometic, or by respectively qualified personnel, in order to prevent any hazards. Plug connection (for United Kingdom only) If a 3-pin 13 amp fused plug is used, it should be fitted with a 3 amp fuse; with other plug types, the circuit should contain a 5 amp fuse. This appliance conforms with the requirements of EEC directive No. 82/449 relating to radio interference. Attention: For GB Only ! Warning - This appliance must be earthed. IMPORTANT The wires in the mains lead of this appliance are coloured in accordance with the following code: GREEN and YELLOW : EARTH BLUE : NEUTRAL BROWN : LIVE As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows. Connect the GREEN and YELLOW coloured wire to the plug terminal marked letter E or earth symbol or coloured green or green and yellow. Connect the BROWN coloured wire to the plug terminal marked letter L or coloured red. Connect the BLUE coloured wire to the plug terminal marked letter N or coloured black. 6 Moulded-On Plug Version The mains lead is fitted with a non-rewirable moulded-on 13 amp plug containing a 3 amp fuse. If the fuse requires replacing at any time, the fuse cover/carrier should be removed using a small screwdriver to level out. The old fuse should be replaced by a 3 amp ASTA approved BS1362 fuse and the fuse cover/carrier must be refitted before the plug is used again. If the fuse cover-carrier is lost, a replaceement can be obtained from the Dometic service Shops. The fuse cover/carrier must be of the same colour as that of the coloured insert in the base of the plug. In no circumstances must the plug be used without a correct fuse cover/carrier fitted. If the plug supplied on the mains lead is not suitable for the socket in your home, it should be cut off and disposed of safely, or destroyed, to avoid any possible shock hazard resulting from the plug being inserted into a 13 amp socket elswhere in the use. A suitable replacement plug should then be fitted as given above. 4. 8 Changing the Sliding Hinge (possible with EA 330) 1. 2. A 1. 2. B 3. 4. Distance to cupboard door (A) 1. When closed, the cupboard door (A) must not lie against the rest of the surrounding cupboard area (distance 1-2mm). There must be a distance of 6-8mm between the cupboard door and the miniCool. 2. mm 7 4. 9 Changing the Doorhang (possible with EA 330) 1. L R 2. 3. 1. 2. 4. 5. 6. 7. [. . . ] When removing goods, only open the miniCool briefly. 12 hours prior to stocking. 5. 10 Declaration of conformity 12 5. 11 Check List Problem: No cooling (the aggregate at the back of the device is cold). Possible Cause a. ) The thermostat is set to 0. d. ) Defective electronics or sensor feelers. [. . . ]