User manual AEG-ELECTROLUX EBR 517-W

[. . . ] Environment concerns Installation GREAT BRITAIN & IRELAND Guarantee/Customer Service The following symbols are used in this user manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information Subject to change without notice 4 Safety information SAFETY INFORMATION Before the installation and use, read this manual carefully: · For your personal safety and the safety of your property · For the respect of the environment · For the correct operation of the appliance. Always keep these instructions with the appliance also if you move or sell it. The manufacturer is not responsible if incorrect installation or use results in damage. Children and vulnerable people safety · This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in safe way and understand the hazards involved. [. . . ] Set an oven function (or programme) and temperature (refer to "Setting the oven function" and "Changing the oven temperature"). Set DURATION (refer to "Setting the DURATION"). Touch again and again until will flash in the display. This dot shows which clock function is activated. Touch any sensor field (apart from ON/OFF) to start the SET+GO function. You can use SET+GO function only if DURATION is set. Check result (selected models only) If you set END or DURATION function, 2 minutes before end of cooking an acoustic signal sounds and lamp activates. The appliance goes to the setting of the END or DURATION function. During these two minutes you can examine the cooking results and, if necessary, add END or DURATION time. Setting the Time delay function DURATION and END can be used at the same time, if the oven is to be switched on and off automatically later. In this case first set DURATION and then END function (refer to "Setting the DURATION" and "Setting the END "). When the Time delay function is activated the display shows static symbol of the oven function, with a dot and . The dot shows which clock function is on in the Clock/ Residual heat display. Setting the MINUTE MINDER Use the MINUTE MINDER to set a countdown (maximum 23 h 59 min). When set time ends, an acoustic signal operates for two minutes. Touch any sensor field or open the oven door to stop an acoustic signal. 19 Automatic programmes with core temperature sensor The core temperature of the food is default and fixed in programmes with core temperature sensor. The programme ends when the appliance is at the set core temperature. Touch again and again until the display shows . Install the core temperature sensor (refer to "The core temperature sensor"). or to set the core temperature sensor programme. Touch When a core temperature sensor programme is set, the display shows the cooking time, and . or the settings save automatically after five seconds. When set time ends, an acoustic signal operates for two minutes. Touch any sensor field or open the oven door to stop an acoustic signal. My Favourite Programme function Use this function to save your favourite settings of temperature and time for an oven function or programme. Set the temperature and time for an oven function or programme. [. . . ] 3 mm 200 cm2 547 546 114 590 560 min. 567 21 594 594 30 Installation 31 max. R1200 mm 130 140 alternativ 100 H05VV-F H05RR-F min. 1600 mm 90º 32 GREAT BRITAIN & IRELAND - Guarantee/Customer Service 2x3, 5x25 GREAT BRITAIN & IRELAND - GUARANTEE/CUSTOMER SERVICE GB IE Standard guarantee conditions We, Electrolux, undertake that if within 12 months of the date of the purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: · Appliance has been correctly installed and used only on the electricity supply stated on the rating plate. [. . . ]