User manual AEG-ELECTROLUX ECG6600

[. . . ] Customer g Dear read this user manual carefully, Please Paying special attention to the safety notes!Keep the manual in a safe place for later reference, and pass it on to any new owner. Key to picture Front view (Figure 1) Milk container (Figure 2) Front view with open service door (Figure 3) 1. 8 Looking up the number of coffees dispensed, number of jugs dispensed and number of descaling procedures (statistics) 130 13. [. . . ] Make sure that you do not turn the knob for setting the grind level too far, as otherwise coffee may come out in drips when dispensing 2 cups. The display automatically jumps back to the menu option «CHOOSE LANGUAGE» after programming. 0 To go back to the coffee mode, press the "MENU" button (Figure 5)or wait about 120 seconds until the appliance automatically jumps back to coffee mode. You can choose between three temperature levels. The coffee temperature levels are defined as follows: «TEMPERATURE LOW» «TEMPERATURE MEDIUM» «TEMPERATURE HIGH» The factory setting is «TEMPERATURE HIGH». You can change this as follows: Press the "MENU" button (Figure 5). If necessary, select another temperature with the scrolling buttons "<" or ">" (Figure 6). When the desired temperature is displayed, confirm it with the"OK" button (Figure 6). You can change this as follows: Press the "MENU" button (Figure 5). If necessary, select another switch-off time with the scrolling buttons "<" or ">" (Figure 6). When the desired switch-off time is displayed, confirm it with the"OK" button (Figure 6). this switch-off time is programmed in accordingly. If "OK" is not pressed, the appliance automatically returns to the coffee mode after about 120 seconds without saving the entries. The display automatically jumps back to the menu option «AUTO SHUTOFF TIME» after programming. To go back to the coffee mode, press the "MENU" button (Figure 5) or wait about 120 seconds until the appliance automatically jumps back to coffee mode. If "OK" is not pressed, the appliance 3 automatically returns to the coffee mode after about 120 seconds without 0 saving the entries. The display automatically jumps back to the menu option «TEMPERATURE» after programming. 0 To go back to the coffee mode, press 13. 4 the "MENU" button (Figure 5)or wait about 120 seconds until the appliance automatically jumps back to coffee mode. You can adjust and change this to suit your taste. The coffee strength can be adjusted in 5 steps from extra mild to extra strong and the filling quantity can be adjusted in 10 steps with the aid of a graphic bar. If the appliance is not used for a while it switches itself off automatically for safety and energy saving reasons. [. . . ] The "Coffee strength / preground coffee" knob was not put into position or and the appliance used both preground coffee and coffee ground by the mill mechanism. Carefully clean the inside of the machine as described below under , , Cleaning the brewing unit" page 132. Repeat the process, first by putting the "Coffee strength / preground coffee" knob in the right position as described under , , Makingcoffee with ground coffee" page 123. 0 Remove the brewing unit and carefully clean the insided of the machine as described under , , Cleaning the brewing unit" page 132. [. . . ]