User manual AEG-ELECTROLUX ECS2370

[. . . ] They contain important information for safe use, for installation and for care of the appliance. Notes which are important for your safety or for the proper functioning of the appliance are stressed with a warning triangle and / or with signal words ( Warning!, Caution!, Important!). This symbol and numbered instructions guide you step by step in the operation of the appliance. Tips and notes concerning economical and environmentally sound use of the appliance are marked with the cloverleaf. The operating instructions contain instructions for the correction of possible malfunctions by the user in the section" What to do if . . . ". [. . . ] - position it where the temperature of the environment corresponds to the climatic classification for which the freezer was designed. Climatic classification Ambient temperature limits Warning: This appliance must be earthed. This appliance complies with the following EC Directives: -73/23/EEC-Low-VoltageDirective -89/336/EEC -EMC Directive. Testing has been carried out in accordance with EN 153 regarding the determination of freezer capacity, energy consumption and temperature rise time. Description of equipment From. . . . to SN +10 to +32 C N +16 to +32 C ST +18 to +38 C T +18 to +43 C If the freezer has been handled in a vertical position it should be allowed to stand in normal position for about 12 hours before switching it on. Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown. Control panel: 1. Signal lamp of the control section (green). Signal lamp (yellow) for quick freezing. Acoustic alarm and alarm signal lamp (red). Push button: - for reset acoustic alarm - for start quick freezing mode - for stop quick freezing mode Electrical Connection Electrical requirements Before switching on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate, located on the back of the cabinet. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. This appliance must be earthed. 58 electrolux cold The manufacturer declines any liability should these safety measures not be observed. Electrical Requirements Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS1362) fuse must be used. Should the plug need to be replaced for any reason. Prior to closing, remove the air from the bags and foils; otherwise , the air causes the to dry out food and, in addition, occupies space. Make small flat packages in order to accelerate the freezing. Do not fill the special boxes to the brim with ice cream or liquid due to the expantion occurring during freezing. Conservation of frozen products Attention!Prior to loading the freezer the first time with food already frozen, the temperature of -18 °C necessary for safe storage should be obtained. Store only frozen foods that are wrapped in order to prevent them becoming dry, loosing their flavour or interacting with the flavour of other frozen foods. Observe the period storage recommended on pre-packed frozen food. Store ice creams and high fat content foods in the lower part of freezer (near the bottom) Preparation of Ice cube maker Cup of the ice cube maker Load line Load line of the ice cube maker electrolux cold 61 1. Fill the ice cube maker until the cubes will be full in the horizontal position or by the load line mark in the vertical position. After this close the ice cube maker with cap. 2. Place the holder in the lid of the freezer and leave to solidify 3. To loosen the frozen cubes, either bend the ice cube tray or hold it under running water for a few seconds. Never try to free an ice tray that is frozen to the freezer compartment using pointed or sharp edged objects. Use a soft plastic scraper. 1. Turn the temperature control knob counterclockwise to"off" position. 2. Remove mains plug 3. For replacement of the bulb press the cover hook and remove as shown in the illustration 4. Replace defective light bulb. [. . . ] Cool hot dishes to room temperature as quickly as possible before placing them in the freezer. Wrap food carefully in freezer foil, or use the special freezer boxes or bags which are on the market. Divide food into small portions before freezing- this ensure that the freezing is more rapid, and means that you only need to defrost the amount needed for immediate consumption. Remember that defrosted food must not be re-frozen. [. . . ]