User manual AEG-ELECTROLUX EDB8040

[. . . ] The plug must be removed from the socket outlet before the water reservoir is filled with water. The mains cable must not come into contact with any hot parts of the appliance. Do not immerse the appliance in water or any other liquid. [. . . ] Using the steam function (for models without auto steam). Turn the steam knob to select the desired steam output for each garment, if selecting the off position, it indicates ironing without steam, the iron can be used as a dry-iron. For models with auto steam control system the steam regulation is done by the temperature selector. when turning it to set temperature , it will automatically adjust steam position , as indicated on the knob. To stop the steam and use as a dry-iron, press down . Use spray mist to pre-dampen fabrics by pressing spray button several times to release a fine mist (A). To use the steam jet function, ensure that tank is at least 1/2 full. If iron is left unattended on soleplate or on the side, it turns off after 30 seconds. If left unattended on the heel, it turns off after 8 minutes. Cleaning (do not use any detergent) Nettoyage (ne pas utiliser de détergent) Always store iron on its heel rest. To clean exterior surfaces, use a damp soft cloth and wipe dry. Do not use any chemical solvents, as these will damage the surface. When the light turns green, unplug, hold it over a sink and pull the steam knob out (for EDB8040 set the steam knob to auto-clean). Insert the steam knob back and press until the click. If the temperature knob is not on MAX position, it will not be possible to pull out or place back the steam knob. Do not use scouring pads or harsh cleaners on the soleplate as these will damage the surface. [. . . ] Water leaks from the soleplate during ironing. Flakes and impurities come out of the soleplate during ironing. Water leaks from the soleplate while the iron is cooling down or after it has been stored. [. . . ]