User manual AEG-ELECTROLUX EDC46130W

[. . . ] We promise that it will provide a superior User Experience delivering Ease-of-Mind. Good luck! GB 125987340. qxp 2007-03-16 11:41 Page 4 4 electrolux contents Contents Safety information . 29 -33 The following symbols are used in this manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information 125987340. qxp 2007-03-16 11:41 Page 5 safety information electrolux 5 Safety Information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. [. . . ] Remove the laundry when the dryer has finished drying. If individual items are still damp after drying, set a brief post-drying time, for at least 30 minutes. This will be necessary particularly for multilayered items (e. g. After air-drying, wool may be dried with the WOOL CARE programme. GB · · · Make sure that no metal objects are left in the laundry (e. g. Button up pillowcases, close zip fasteners, hooks and poppers. Remove persistent stains before washing. Rub particularly soiled areas with a special detergent or detergent paste. Remove hooks or tie them up in a bag or net. · · 125987340. qxp 2007-03-16 11:42 Page 14 14 electrolux drying hints Maximum loads Recommended loads are indicated in the programme charts. General rules: Cotton, linen: drum full but not too tightly packed; Synthetics: drum no more than half full; Delicate fabrics and woollens: drum no more than one third full. Try to load to the maximum capacity of the machine as small loads are uneconomical Load It is often difficult to estimate the weight of items to be dried. We therefore recommend that you adopt the following guidelines: · cotton, linen: drum full but not too tightly packed; · synthetics: drum no more than half full; · delicate fabrics: drum no more than one third full. Turn the programme selector dial to switch on the appliance. In selection mode, press simultaneously the buttons DRYNESS and START. Press the buttons down until until «C0» appears on the digits. Adjusting the level of conductivity: Press the START/PAUSE button sequentially: the level of conductivity is indicated by the lighting of the horizontal hyphens. Normally, the appliance is factory-set to the highest level; however, certain models may be configured differently. Memorizing the new setting: Display Conductivity Approximate value uS/cm CO CO CO Low Medium High <300 300-600 >600 Simultaneously press the buttons DRYNESS and START. Press the buttons down until the previous drying cycle time appears again on the display and the buzzer sounds. O = Cancelling/OFF To reset a programme and to switch off the machine turn the selector dial to O. Now a new programme can be selected. 125987340. qxp 2007-03-16 11:42 Page 18 18 electrolux care and cleaning Care and cleaning You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. External cleaning Use only soap and water and then dry thoroughly. Important: do not use methylated spirit, diluents or similar products. The filter in the inner door must be removed for cleaning. Cleaning the door Clean periodically the interior part of the door to remove any fluff from the seals around the filter. Accurate cleaning ensures correct drying. Do not be alarmed by the amount of fluff. [. . . ] · The appliance has been used for normal domestic purposes only, and in accordance with the manufacturer's instructions. · The appliance has not been serviced, maintained, repaired, taken apart or tampered with, by any person not authorised by us. · All service work under this guarantee must be undertaken by a Service Force Centre. · Any appliance or defective part replaced shall become the Company's property. [. . . ]