User manual AEG-ELECTROLUX EDC5370

[. . . ] C o n d e n s e r D r y e r Operating Instructions EDC 5370 822 944 171 - 01 - 1201 g Dear customer, Please read these operating instructions through carefully. Please make sure you read the safety instructions on the first pages of these operating instructions!Keep the operating instructions for future reference. Pass them on to any future owners. 1 With the warning triangle and/or by means of key words (Danger!, Caution!, Attention!), information is emphasized which is important for your safety or the correct functioning of the appliance. [. . . ] AUDIBLE SIGNAL (SIGNAL) button During the crease-protection phase (immediately after the drying process), an acoustic signal is sounded at certain intervals (see "End of drying process"). QUICK DRY (KURZ) button The selected programme runs on a shortened programme to produce the same degree of drying. The QUICK DRY (KURZ) button cannot be used with COTTONS DAMP (BAUMWOLLE LEICHTTROCKEN), HAND IRON (BÜGELTROCKEN) and MACHINE IRON (MANGELTROCKEN) programmes or with the DELICATES DAMP (MISCHGEWEBE LEICHTTROCKEN) programme. The QUICK DRY (KURZ) button has no effect if the SPECIAL CARE (SCHON) button has already been pressed. · · Start time pre-selection Using the delay start timer you can delay the start of the drying programme by 3, 6 or 9 hours. Hold the DELAY TIMER (ZEITVORWAHL) button depressed until the desired number of hours of delay of the program start appears in the display panel. 3. Press the START/PAUSE (START/PAUSE) button. After elapse of the set number of hours the dryer automatically starts the set drying program. The number of hours until the set drying programme is due to begin is shown in the display panel. You can correct the pre-selected start delay time at any time. button START/PAUSE (START/ The drying programme begins. You can check the progress of the drying procedure in the programme progress display. Removing laundry or loading laundry when necessary You can interrupt the drying process at any time to remove some of the laundry or to add more laundry. The laundry and the drum may be hot. 2. Press the START/PAUSE (START/PAUSE) button to resume the drying process. End of the drying process The cooling phase starts shortly before the end of the drying process: The heater is switched-off during this phase. After the cooling phase the END / CREASE GUARD (ENDE / KNITTERSCHUTZ) display is illuminated. You can now remove the washing from the tumble dryer. The crease guard phase follows automatically after the drying process. For 30 minutes the drum rotates intermittently. This keeps your laundry loose and crease-free. If you have pressed the AUDIBLE SIGNAL (SIGNAL) button, an acoustic signal is sounded intermittently during this phase. You should remove the washing at the latest towards the end of the anti-crease phase to avoid creasing. Removing the laundry 1. Open the door and remove the laundry. 14 Empty the water reservoir 1 Caution!The condensed water is not suitable for drinking or for use with foodstuffs. [. . . ] The plug must be installed in phase in accordance with the rating plate (it is essential that phase L of the socket is contacted with the brown wire of the mains cable). Improper connection can lead to the risk of a fire in the dryer. 24 Special accessories You can obtain the following special accessories from your retailer: Drainage kit With this kit (E-No. 916 019 000) you can lead the condensate directly into a drain (sink, siphon, drain grating) with a maximum feed height of 1m above the floor on which the dryer is standing (3m Length). Emptying he condensate container is then no longer necessary. [. . . ]