User manual AEG-ELECTROLUX EDC595E

[. . . ] Points which are necessary for your safety or which are important for the unit's functional capability are highlighted by a warning triangle and/or signal words (Warning!, Caution!, Attention!). This numbers guide you step by step in operating the unit. . . . 3 2 After this symbol you will find detailed information on operation and practical use of the unit. The clover leaf indicates tips and information on the economical and environmentallyresponsible use of the unit. This user information contains information on remedying any faults which may occur, see the section "What to do if . . . ". 2 Contents Instructions for use . [. . . ] Push down unlock button on large mesh filter. It is best to use a damp hand for this purpose. 13 Clean the entire filter area 3 The strainer area does not have to be cleaned after every drying cycle, but should be checked regularly and cleaned of fluff if necessary. To do this, grip the top of the large mesh filter and pull it forwards until it comes loose from the two brackets. Remove fluff from the entire filter area. It is best to use a vacuum cleaner for this purpose. Press both journals of the large mesh filter into the brackets on the loading door until they snap into place. Re-insert fine strainer. 3 If thewill not snapisinto place and the loading fine strainer not fitted, the large mesh filter door cannot be closed. 10. Press against the large mesh filter until it locks into the interlock. Cleaning the door seal Wipe the door seal with a damp cloth immediately after the drying cycle has finished. 14 Emptying the condensate tank Empty condensate tank after every drying cycle. If the condensate tank is full, an active programme will break off automatically and the EMPTY WATER (BEHÄLTER) display will light up. In order to continue the programme, the condensate tank must first be emptied. 1 Warning!The condensate is not suitable for drinking or for preparing foodstuffs. Pull drawer containing condensate tank out all the way (1). cleaninguse furniture cleaners or magressive agents to clean the a barely visible lining on the inside of the drum. The degree to which the laundry has been dried is then no longer detected reliably. The laundry is damper than expected when removed from the dryer. vinegar-based cleaner) to wipe down the inside of the drum and drum ribs. Clean operating screen and housing chine. Use a damp cloth to wipe down the operating screen and housing. What to do if. . . ? Troubleshooting by yourself If, during operation, the dryer shows an error display (one or more displays flashing on the programme progress display), check first of all whether you can remedy the problem yourself by means of the table below. If you cannot solve the problem: Switch the machine off and on again. If the error display is still shown, please contact our after-sales service and inform them which displays are flashing. Problem Possible cause Remedy Mains plug is not plugged in or fuse Plug in at mains socket. Have you pressed the START/ PAUSE button?Ventilation slots in base area covered up. Select a different programme the next time you dry (see "Overview of programmes" section). Uncover ventilation slots in base area. Residue on inside surface of drum or Clean inside surface of drum and drum drum ribs. [. . . ] Unscrew cover plates E from the front of the machine, rotate through 180, screw on the opposite side. Unscrew door lock F, push down slightly and remove from the front of the machine. Press snap-in button G in and down, press cover down slightly and remove from front of the machine. 10. Transfer door lock F to the oppositeside and screw down. [. . . ]