User manual AEG-ELECTROLUX EDC78550W

[. . . ] Important safety information Environment Product description Control panel Before first use Programme chart Daily use 2 4 4 5 5 6 7 Cleaning and maintenance 10 What to do if . In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] DELICATE is only suitable for use with loads of up to 3kg. By depressing button Buzzer (Buzzer) the acoustic signal is switched off in the following cases: When the programme selector dial is turned to another position during the programme or when you depress an option button during the cycle · The relevant light will light up. Press the DRYNESS (Dryness) button as many times as necessary until the small light at the level of residual dampness required is illuminated. When the programme has finished the pilot lights End is on. time (Time) Use the Time (Time) button to select the programme duration after setting the Time programme. You can select a programme duration from 20 min. Delay (Delay) With the Delay (Delay) button, you can delay the start of a programme by between 30 minutes (30') and a maximum of 20 hours (20h). Press the Delay (Delay) button as many times as necessary until the required time of the delay appears on the display, e. If the display is showing H and you press the button again, the time delay will be cancelled. Setting child lock The child lock can be set to prevent a programme being accidentally started or a programme in operation being accidentally changed. the child lock function locks all buttons and the programme selector. The child lock can be activated or deactivated by holding down the Buzzer (Buzzer) and Time (Time) buttons simultaneously for 5 seconds. ­ Before programme is started: Appliance cannot be used ­ After programme is started: Programme in operation cannot be changed appears in the display to indiThe icon cate that the child safety device is activated. The child safety device is not deactivated once the programme comes to an end. If you want to set a new programme, you must first deactivate the child safety device. The condensate can be used as distilled water, e. With a coffee filter) to remove any residue and small pieces of fluff. Cleaning heat exchanger HEAT EXCHANGER is displayed, If the the heat exchanger needs to be cleaned. Operating when the heat exchanger is blocked with fluff can damage the dryer. Clean the door seal Wipe the door seal with a damp cloth immediately after the drying cycle has finished. emptying the water reservoir Empty the water reservoir after every drying cycle. If the water reservoir is full, an active programme will break off automatically and the icon on the display will empty container light up. [. . . ] Should the appliance be moved, it must be transported vertically. The appliance must not be installed behind the lockable door, a sliding door a door with a hinge on the opposite side to that of the appliance in such a way that a full opening of the dryer is restricted. removing transport safety packaging Caution!Before use all parts of the transport packaging must be removed. [. . . ]