User manual AEG-ELECTROLUX EDD210

[. . . ] Read all instructions before installing the dishwasher. For your safety, please read and observe all safety instructions. This guide will help you anticipate electrical, water, and drain connections and help you select the best location for the dishwasher. 3 WARNING Tip Over Hazard ­ Do not use dishwasher until completely installed. Failure to follow this warning can result in serious injury and void your warranty. QUESTIONS? 1-877-4Electolux (United States and Canada) INTERNET For online support and product information, in the U. S. [. . . ] Electrical, water and drain connections are not the same for all age, brands or models of dishwasher. Check the location and length of home utilities. A 15-20 amp, grounded 120 volt AC only electrical supply is required. If the dishwasher drain hose will be connected to a food disposer for the first time, remove knock out plug covering disposer inlet. Kinked water and drain hoses can cause problems. Dishwasher need to be connected to a hot water supply with enough water pressure to ensure an adequate fill. See Making the Water Connection, page 10. You will need additional parts listed above to complete the installation. See Materials Needed for Installation, page 5. Flush water line prior to making the final connection to prevent clogging of the inlet valve filter screen. See Finishing the Water Connection, page 16. Property damage resulted from actions described will void the warranty. An existing or new, copper or stainless steel braided line, rated for dishwasher use, should attach the dishwasher to the water supply line. Be sure water inlet is protected from freezing. If valve freezes and ruptures, flooding may occur. Determine the amount of tubing needed to connect the hot water supply to the unit's water inlet valve. Copper tubing must have a minimum of 3/8" OD. High-pressure and high-temperature rated plastic tubing with a minimum inner diameter of 1/4" may be used. A shut-off valve installed outside the dishwasher cabinet is recommended. See Figure 3, page 11. CAUTION Making the Connections 2. Cut water access hole in cabinet as shown in Figure 3. Route water supply line to installation area. Through Cabinet 11 Figure 3 NOTE Incoming hot water temperature, set at the hot water heater, should be 120° F (49° C). [. . . ] The type of hose used should be consistent with the type and diameter installed on the dishwasher. Secure the drain hose to the air gap, water tee or disposer with clamps. Make sure the drain hose is not kinked. NOTE 1 When connecting the drain line to the disposer, check to be sure that the knockout plug has been removed. DISHWASHER WILL NOT DRAIN IF THE PLUG IS LEFT IN PLACE. 2 20 Completing the Installation INSTALLING THE TOEKICK 1. [. . . ]