User manual AEG-ELECTROLUX EDH2800

[. . . ] Points which are necessary for your safety or which are important for the unit's functional capability are highlighted by a warning triangle and/or signal words (Warning!, Caution!, Attention!). This numbers guide you step by step in operating the unit. . . . 3 2 After this symbol you will find detailed information on operation and practical use of the unit. The clover leaf indicates tips and information on the economical and environmentallyresponsible use of the unit. This user information contains information on remedying any faults which may occur, see the section "What to do if . . . ". 2 Contents Instructions for use . [. . . ] 5. Close loading door. 3 Until theatstart of the programme thethe laundrum is moved longish intervals to loosen dry. 3 The drying cycles (except for the WOOL pro- Starting the programme Press the START/PAUSE button. The programme progress display and the display showing the level of dryness show drying progress. Changing programme To change a programme which has been selected by mistake once the programme has started, first turn the programme selector to OFF (AUS) and then reset the programme. 3 The programmeprogramme hasbe changednevcan no longer directly once the started. If ertheless there is an attempt to change the programme on the programme knob, the programme progress display and the maintenance indicators flash. If an option button (excluding the AUDIBLE SIGNAL (SIGNAL) button) is pressed, Err appears in the multidisplay. The drying programme is not however affected by this (laundry protection). 12 Cleaning and maintenance Cleaning fluff filter To ensure that the dryer works perfectly, the fluff filters (micro-fine filter and fine strainer) must be cleaned after every drying cycle. filters or with damaged or blocked fluff filters. Use a damp hand to clean the micro-fine filter, which is built into the lower part of the loading aperture. 1 Caution!Never operate the dryer without fluff 3. Push down unlock button on large mesh filter. It is best to use a damp hand for this purpose. 13 Clean the entire filter area after every drying cycle, but should be checked regularly and cleaned of fluff if necessary. To do this, grip the top of the large mesh filter and pull it forwards until it comes loose from the two brackets. Remove fluff from the entire filter area. To clean the filter mat: Remove filter mat from filter housing. To do this, press the pressure points on the sides and pull the filter mat and frame up and out of the housing. Take the filter mat out of the frame and wash it by hand or use a vacuum cleaner, when it is has dried out. Fluff, which has become stuck in the filter mat and has not been removed by washing, does not affect the function. 8. Insert the filter mat in the frame and then insert with the frame into the filter housing. 1 Important: The filter mat must engage tightly with the frame. Check that the mat is sitting snuggly in the frame, especially after inserting it into the filter housing. 3 The 9. once every 6 months, remove the fluff from the heat exchanger using the sponge supplied. When doing this, please use rubber gloves. Tip: The fluff can be removed more easily if it is first dampened e. 10. Re-insert filter housing with frame and filter mat in the base of the appliance. Note: If the filter mat and frame are not inserted in the filter housing, the filter housing cannot be pushed into the base of the appliance. [. . . ] Unscrew cover plates E from the front of the machine, rotate through 180, screw on the opposite side. Unscrew door lock F, push down slightly and remove from the front of the machine. Press snap-in button G in and down, press cover down slightly and remove from front of the machine. 10. Transfer door lock F to the oppositeside and screw down. [. . . ]