User manual AEG-ELECTROLUX EDH97961W

[. . . ] Important safety information Environment Installation Product description Control panel Before first use Programme chart 54 56 56 59 59 60 60 Daily use Drying rack Care and cleaning What to do if . Subject to change without notice In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mistakes and accidents, it is important to ensure that all people using the appliance are thoroughly familiar with its operation and safety features. Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. [. . . ] removing transport safety packaging Caution!Before use all parts of the transport packaging must be removed. Pull off adhesive strips from inside machine on top of drum. Before appliance use all packaging parts and drying rack must be removed from the drum. Lift slightly rack and take it carefully out from the drum. Comply with the above safety precautions. Should the appliance power supply cable need to be replaced, this must be carried out by our Service Center. The plug must be accessible after installing the machine. Door reversal To make it easier to load or unload the laundry, the door can be reversed. The engineer will carry out the door reversal at your cost. special accessories · Stacking kit These intermediate installation kits can be used to arrange the dryer and a washing machine (60 cm wide, front loaded) as a space-saving washer/dryer stack. the washing machine is at the bottom and the dryer is at the top. Read carefully the instructions supplied with the kit. Available from your Service Force Centre or your specialist dealer · draining kit Installation kit for direct draining of the condensed water into a basin , siphon , gully , etc. The water reservoir then no longer has to be drained, it must however remain in its intended position in the machine. Fixed hose has to be on the suitable height from minimum of 50 cm to maximum of 1 m from floor level and cannot be looped. Read carefully the instructions supplied with the kit. Available from your Service Force Centre or your specialist dealer · Pedestal with the drawer To situate the dryer at the optimal height and have some additional space to store (e. Electrical connection Details on mains voltage, type of current and the fuses required should be taken from the type plate. The manufacturer declines any responsibility for damage or injury through failure to Read carefully the instructions supplied with the kit. Available from your Service Force Centre or your specialist dealer 2 3 4 5 6 7 8 9 10 11 12 13 14 Water reservoir Fine fluff filters Drum light Loading door (reversible) Drying rack Course fluff filters Fluff filters Push button for base door opening Rating plate Airflow grille Fluff filter Adjustable feet Heat exchanger door Minimal dryness level Medium dryness level Maximal dryness level Auto dryness level Time to end (time of time programme, time of start delay) Cycle performance, auto dryness detection Long anti-crease guard Description Anti-crease guard phase Error, wrong selection In order to remove any residues which may have been produced during production, wipe the dryer drum with a damp cloth or carry out a brief drying cycle (ca. ) there could be a slightly higher sound level. [. . . ] Turn it to DRUM LIGHT (if available) or to any programme. Automatic process; this is not a machine fault. empty water reservoir3) , press START PAUSE button. Select time programme or higher drying level (e. [. . . ]