User manual AEG-ELECTROLUX EDM8100

[. . . ] Points which are necessary for your safety or which are important for the unit's functional capability are highlighted by a warning triangle and/or signal words (Warning!, Caution!, Attention!). This numbers guide you step by step in operating the unit. . . . 3 2 After this symbol you will find detailed information on operation and practical use of the unit. The clover leaf indicates tips and information on the economical and environmentallyresponsible use of the unit. This user information contains information on remedying any faults which may occur, see the section "What to do if . . . ". 2 Contents Instructions for use . [. . . ] After each drying cycle ­ clean the micro-fine filter and fine strainer, ­ drain the condensate tank (refer to the "Cleaning and maintenance" section). Close loading door. 12 Cleaning and maintenance Cleaning fluff filter To ensure that the dryer works perfectly, the fluff filters (micro-fine filter and fine strainer) must be cleaned after every drying cycle. 1 Caution!Never operate the dryer without fluff filters or with damaged or blocked fluff filters. Use a damp hand to clean the micro-fine filter, which is built into the lower part of the loading aperture. 3. Push down unlock button on large mesh filter. It is best to use a damp hand for this purpose. 13 Clean the entire filter area 3 The strainer area does not have to be cleaned after every drying cycle, but should be checked regularly and cleaned of fluff if necessary. To do this, grip the top of the large mesh filter and pull it forwards until it comes loose from the two brackets. Remove fluff from the entire filter area. It is best to use a vacuum cleaner for this purpose. Press both journals of the large mesh filter into the brackets on the loading door until they snap into place. Re-insert fine strainer. 3 If thewill not snapisinto place and the loading fine strainer not fitted, the large mesh filter door cannot be closed. 10. Press against the large mesh filter until it locks into the interlock. Cleaning the door seal Wipe the door seal with a damp cloth immediately after the drying cycle has finished. 14 Emptying the condensate tank Empty condensate tank after every drying cycle. Replace heat exchanger and lock into place (turn both lock washers outwards until they snap into place). Close base door. 16 Cleaning the drum 1 Caution!Do not use abrasives or steel wool to clean the drum. Do not ag3 Lime in the water or cleaning agents may form 1 Caution!cleaninguse furniture cleaners or magressive agents to clean the a barely visible lining on the inside of the drum. The degree to which the laundry has been dried is then no longer detected reliably. The laundry is damper than expected when removed from the dryer. vinegar-based cleaner) to wipe down the inside of the drum and drum ribs. Clean operating screen and housing chine. Use a damp cloth to wipe down the operating screen and housing. What to do if . . . Troubleshooting by yourself If, during operation, the error code (E plus number or letter) appears on the multi-display: Switch the machine off and on again. Press the START/PAUSE button Problem If the error is still displayed, please inform our aftersales service and quote the error code. Possible cause Remedy Mains plug is not plugged in or fuse Plug in at mains socket. Have you pressed the START/ PAUSE button? [. . . ] 10. Press snap-in button G in and down, press cover down slightly and remove from front of the machine. 11. Disconnect cable connector from cover G. 12. Change door lock F over to the opposite side, insert the cable connector and screw down the door interlock. 13. On the other side, insert the cable connector in cover G, insert cover and allow snap-in button to lock into place. [. . . ]