User manual AEG-ELECTROLUX EFA12545X

[. . . ] Never use the hood for purposes other than for which it has ben designed. Never leave high naked flames under the hood when it is in operation. Adjust the flame intensity to direct it onto the bottom of the pan only, making sure that it does not engulf the sides. Deep fat fryers must be continuously monitored during use: overheated oil can burst into flames. [. . . ] DUCTED VERSION AIR EXHAUST SYSTEM When installing the ducted version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 120 mm, the choice of which is left to the installer. Fix the pipe in position using sufficient pipe clamps (not supplied). Fix the connection 15 to the frame using the 4 screws provided. Fix the flange 10 to the lower opening of the connection 15. Connect the hood air outlet to the flange in the lower part of the junction using a rigid or flexible ø 150 tube (by installer's 10 choice). Position the upper chimney section and fix the upper part to the frame using the 2 screws 12c (2, 9 x 6, 5) provided. Similarly, position the lower chimney section and fix the lower part to the frame using the 2 screws 12c (2, 9 x 6, 5) provided. Before fixing the hood body to the frame: · From below, use the 4 screws 12f (M6 x 10)provided to fix the hood body to the frame. Connect the hood to the mains through a two-pole switch having a contact gap of at least 3 mm. Place the connectors in the junction box 24 and close it using the 2 screws 12e (2, 9 x 9, 5) provided. Fix the junction box to the hood body using the 2 screws 12c (2, 9 x 6, 5) provided. The hood can be switched on pushing directly onto the requested speed without firstly having to select 0/1 button . When pressed for 2 seconds it starts the lighting system in "courtesy light" mode. The lamps are fed at a reduced power of approximately 5W. Such function can be stopped by pressing the touch control for 2 seconds or just by pressing it shortly in order to return to the normal lighting mode. In courtesy light mode the touch control is not lit. When pressed the motor is stopped, regardless of the speed it is set to. When pressed the motor is set to the first speed By a brief pressing the motor is set to the second speed. [. . . ] Fit the new filter and fasten it its correct position. Put the metal grease filters in their seats. Remove the 2 screws fixing the Lighting support, and pull it out of from the Hood. Replace with another of the same type, making sure that the two pins are properly inserted in the lamp holder socket holes. [. . . ]