User manual AEG-ELECTROLUX EFA55

[. . . ] If the instructions for installation for the gas hob specify a greater distance, this must be adhered to. Before any cleaning or maintenance operation, disconnect the hood from the mains by removing the plug or disconnecting the home mains switch. The appliance is not intended for use by children or persons with impaired physical, sensorial or mental faculties, or if lacking in experience or know-how, unless they are under supervision or have been trained in the use of the appliance by a person responsible for their safety. Children should be monitored to ensure that they do not play with the appliance. [. . . ] For more detailed information about treatment, recovery and recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. This appliance is marked according to the European directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE). The cooker hood is designed to from extract unpleasant odours from the kitchen, it will not extract steam. The hood is supplied as an extractor unit and can also be used in recirculation mode by fitting a charcoal filter. In this mode fumes are extracted to the outside via a hose connected to the coupling ring ring. In order to obtain the best performance the hose should have a diameter equal to the outlet hole. The air is filtered through a charcoal charcoal filter and returned to the kitchen. You will need an original charcoal filter for the recirculation mode. Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. You are therefore strongly recommended to follow these instructions. The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Prior to touching the light bulbs ensure are ensure they are cooled down. Replace the old bulb with a new one of the same type (12V max 20W G4). If the light does not come on, make sure the bulb has been inserted in correctly before contacting your local Service Force Centre. Clean the outside of the hood using a damp cloth and a solution of water and mild washing up liquid. Only ever clean the switch panel and filter grill using a damp cloth and mild washing up liquid. Clean all the plastic parts with a soft cloth soaked in warm water and neutral soap. It is extremely important to clean the unit and change the filters at the recommended intervals. Failure to do so will cause grease deposits to build up that could constitute a fire hazard. If your appliance fails to work properly please carry out the following checks. [. . . ] In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. Power: Motor: Lighting: Length of the cable: Electrical connection: Fuse rating: Mounting accessories included 1 reduction flange Ø 120 mm 2 screws 3, 9 x 32 mm 2 Wall dowels Ø 6 mm (for wall mounting) 4 Wall dowels Ø 8 mm (for wall mounting) 4 screws 5 x 45 mm 46 screws 3, 5 x 9, 5 mm 4 screws 2, 9 x 6, 5 2 screwdriver bits (for TORX screws) 71÷ Warnings Safety warnings for the electrician The mains power supply must correspond to the rating indicated on the plate situated inside the hood. If provided with a plug connect the hood to a socket in compliance with current regulations and positioned in an accessible area. If it not fitted with a plug (direct mains connection) or if the plug is not located in an accessible area apply a bi-polar switch in accordance with standards which assures the complete disconnection of the mains under conditions relating to over-current category III, in accordance with installation instructions. [. . . ]