User manual AEG-ELECTROLUX EFA90600X

[. . . ] Children should not be allowed to tamper with the controls or play with the appliance. Never use the hood without effectively mounted grating!The hood must NEVER be used as a support surface unless specifically indicated. The premises where the appliance is installed must be sufficiently ventilated, when the kitchen hood is used together with other gas combustion devices or other fuels. [. . . ] The symbol on the product, or on the documents accompanying the product, indicates that this appliance may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. Disposal must be carried out in accordance with local environmental regulations for waste disposal. For further detailed information regarding the process, collection and recycling of this product, please contact the appropriate department of your local authorities or the local department for household waste or the shop where you purchased this product. The control switches are located on the unit's front panel: 1. Motor ON/OFF button By pressing the button, the hood starts at speed 1. Pressing the button (OFF) while the hood is in function turns the latter off. Speed increase button By pressing the button, the hood starts at speed 1. Pressing the button (while the hood is on) modifies the motor speed: Speed 1: the number "1" appears on the display Speed 2: the number "2" appears on the display Speed 3: the number "3" appears on the display High-speed: the number "4" appears (flashing) on the display The high-speed function is regulated by a timer. The standard time setting is 5', at the end of which the hood adjusts to speed 2. Press button 2 to deactivate this function before the set time expires; the hood will adjust to speed 1. Speed timer button This function allows to time the extracting speed (power) selected and can be activated by pressing key 2 for about 3 seconds, after the time has elapsed the hood switches off. the timer functions in the following way: · Speed 1 - 20 minutes (the number "1" and a small flashing LED light appear on the display) · Speed 2 - 15 minutes (the number "2" and a small flashing LED light appear on the display) · Speed 3 - 10 minutes (the number "3" and a small flashing LED light appear on the display) · High-speed - 5 minutes (the number "4" and a small flashing LED light appear on the display) To quit the timed mode press key 1 to switch off the hood in advance; press key 2 to get back to the previous speed and setting, press key 4 to activate the Sensor mode. Grease filter indicator After 80 hours of operation, the number "1" starts flashing on the display. press and hold button 1 or 3 to reset the indicator. Carry out maintenance on the grease filter according to the indications of this manual. Charcoal filter indicator After 320 hours of operation, the number "2" starts flashing on the display. press and hold button 1 or 3 to reset the indicator. Carry out maintenance on the charcoal filter according to the indications of this manual. When both filter signals appear simultaneously, numbers "1" and "2" will alternately flash on the display. reset the indicator by performing the above-mentioned procedure twice. The first operation resets the grease filter indicator, while the second operation resets the charcoal filter indicator. [. . . ] 25-30 The grease filter must be cleaned once a month using non aggressive detergents, either by hand or in the dishwasher, which must be set to a low temperature and a short cycle. When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering capacity. charcoal filter (filter version only) Fig. 27 The saturation of the charcoal filter occurs after more or less prolonged use, depending on the type of cooking and the regularity of cleaning of the grease filter. [. . . ]