User manual AEG-ELECTROLUX EFA9150X

[. . . ] The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. use · The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. Never use the hood for purposes other than for which it has ben designed. Never leave high naked flames under the hood when it is in operation. [. . . ] Tighten the two screws and fasten the other two screws provi-ded with the hood. Before tightening the screws completely it is possible to adjust the frame by turning it. Make sure that the screws do not come out of their seats in the slotted holes. The frame mountings must be secure to withstand the weight of the hood and any stresses caused by the occasional side thrust applied to the device. In all cases where the ceiling is not strong enough at the suspension point, the installer must provide strengthening using suitable plates and backing pieces anchored to the structurally sound parts. When installing the ducting version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 125 mm, the choice of which is left to the installer. Fix the pipe in position using sufficient pipe clamps (not supplied). Fix the pipe in position using sufficient pipe clamps (not supplied). Fix the connection 15 to the frame using the 4 screws provided. Fix the flange 10 to the lower opening of the connection 15. Connect the hood air outlet to the flange in the lower part of the junction using a rigid or flexible ø 150 tube (by installer's choice). Position the upper chimney section and fix the upper part to the frame using the 2 screws 12c (2, 9 x 6, 5) proEN vided. Similarly, position the lower chimney section and fix the lower part to the frame using the 2 screws 12c (2, 9 x 6, 5) provided. Before fixing the hood body to the frame: · From below, use the 4 screws 12f (M6 x 10)provided to fix the hood body to the frame. Connect the Hood to the Mains power sup-ply, inserting a two-pole Switch with a con-tact aperture of at least 3 mm. On "Maintenance") and make sure that the power supply Cable is properly inserted in the Suction fan socket. 1 and pass them through the slot formed on the galva-nized diffuser support, as shown in fig. Position the finishing plug 27 over the housing in the diffuser support, fixing it us-ing a screw 12e (2. Store both the Connectors in the Protective box 24 and close it with 2 Screws 12e (2. Remove the protective film from the dou-ble-sided adhesive on the connection box, and fix it inside the motor compartment fig. [. . . ] This filter cannot be washed or regenerated, and must be replaced when the F touch control starts to flash, or at least once every 4 months. The alarm is only triggered when the motor is on. Disconnect the mains power supply to the hood by removing the motor unit power supply cable connector, switching off the power supply at the Mains or turning the Main switch off. Release the touch control, touch controls L, T2 and F will light up normally. [. . . ]