User manual AEG-ELECTROLUX EFA9480X

[. . . ] The kitchen must have an opening communicating directly with the open air in order to guarantee the entry of clean air. use · The extractor hood has been designed exclusively for domestic use to eliminate kitchen smells. Never use the hood for purposes other than for which it has ben designed. Never leave high naked flames under the hood when it is in operation. [. . . ] Before tightening the screws completely it is possible to adjust the frame by turning it. Make sure that the screws do not come out of their seats in the slotted holes. The frame mountings must be secure to withstand the weight of the hood and any stresses caused by the occasional side thrust applied to the device. In all cases where the ceiling is not strong enough at the suspension point, the installer must provide strengthening using suitable plates and backing pieces anchored to the structurally sound parts. When installing the ducting version, connect the hood to the chimney using either a flexible or rigid pipe ø 150 or 125 mm, the choice of which is left to EN the installer. Fix the pipe in position using sufficient pipe clamps (not supplied). Fix the pipe in position using sufficient pipe clamps (not supplied). Fix the connection 15 to the frame using the 4 screws provided. Fix the flange 10 to the lower opening of the connection 15. Connect the hood air outlet to the flange in the lower part of the junction using a rigid or flexible ø 150 tube (by installer's choice). Position the upper chimney section and fix the upper part to the frame using the 2 screws 12c (2, 9 x 6, 5) provided. Similarly, position the lower chimney section and fix the lower part to the frame using the 2 screws 12c (2, 9 x 6, 5) provided. Before fixing the hood body to the frame: · Screw the 2 screws 12f half way into the holes provided in the sides of the bottom of the frame. Working from below, fix the hood canopy to the frame (B), using the 4 screws 12q and 4 washers 22 provided, then tighten all the screws securely. Connect the hood to the mains through a two-pole switch ha-ving a contact gap of at least 3 mm. Place the connectors in the junction box 24 and close it using the 2 screws 12e (2, 9 x 9, 5) provided. Fix the junction box to the hood body using the 2 screws 12c (2, 9 x 6, 5) provided. The hood can be switched on pushing directly onto the requested speed without firstly having to select 0/1 button EN When pressed for 2 seconds it starts the lighting system in "courtesy light" mode. [. . . ] The alarm is only triggered when the motor is on. Disconnect the mains power supply to the hood by removing the motor unit power supply cable connector, switching off the power supply at the Mains or turning the Main switch off. Release the touch control, touch controls L, T2 and F will light up normally. Within 3 seconds press the touch control F until the key itself flashes to confirm as follows: · Press the touch control F for at least 4 seconds, until the touch control T1 flashes. [. . . ]