User manual AEG-ELECTROLUX EFA9620X

[. . . ] 9 - Before carrying out any kind of maintenance or cleaning, disconnect the hood from the mains supply. 10 - If the room where the cooker hood is to be used contains a fuel burning appliance such as a central heating boiler then this must be of the room sealed or balanced flue type. If other types of flue or appliance are fitted, ensure that there is an adequate supply of air into the room. [. . . ] Some installation systems require the opening and removal of the metal grille panel. To open the grille panel, press inwardly on the two slider catches at each side of the grille panel and the grille will pivot down. To remove the metal grille, pull forward on the right hand side so that the hinge pin on the back of the grille will be released from the slot in the side of the casing. A - Predrilled wall cabinet: fix the hood onto the wall cabinet base panel using the four screws 4. 1 - If the hood is provided with a paper fixing template, follow the instructions. 2 - If the hood is not provided with a paper fixing template, position the hood on the wall cabinet base panel and pilot drill the 3. 5 x 16 mm screws (not supplied with the fixing kit) from the inside onto the wood. A - Drill two Ø 8 mm holes on the wall using the paper template, insert two rawl plugs and two 4. B - If the hood is not provided with a paper fixing template, drill two Ø 8 mm holes (see draw. lt is fitted onto the reverse side of the metal grille panel. Maintenance of the grease filter varies according to the used type. A - Whatever type of filters used, the filter is easily removed from the grille by pushing the metal wire clips to one side and removing. b - Thin synthetic filter (1 mm thick). It should not be washed and should be replaced every two months. if the filter is provided with a saturation indicator , replace when: b. 1 - The violet colour of the dots, which are visible through the metal grille, is spread over the whole surface of the filter. 2 - The red colour of the stripes, which is not visible through the metal grille when the filter Is clean, becomes visible from the outside of the metal grille. It should be washed every two months in hot water using mild detergent and should be squeezed dry, not wrung out. [. . . ] It should be washed every two months in hot water using mild detergent and should be squeezed dry, not wrung out. It should be washed once a month in hot water using mild detergent or liquid soap. It should not be bent and should be left to drain dry. [. . . ]